Electronics Forum | Mon Mar 04 03:56:37 EST 2002 | wbu
As I recall you need to connect them via serial interface. Make sure the setting on both sides is matching and that you have Rx and Tx connected in your cable. Don�t remember any troubles with data exchange with this baby. Wolfgang
Electronics Forum | Sun Mar 03 07:22:03 EST 2002 | rkey
Hi, We've got one CSM60 and one CSM60V! After searching for a long time i've found the CSM Toolbox (/10) for UFO FIles !! Now i want to connect those machine's to a PC but i've tried everyhing but it doesn't work !! Does someone have experiance wi
Electronics Forum | Mon Mar 04 06:12:37 EST 2002 | rkey
i've send a message including a attachment to your email! Maybe you can help us.
Electronics Forum | Tue Mar 05 00:11:22 EST 2002 | djarvis
CSM60 - I presume is the same as Yamaha6020/21 series? Are you running UFOS, ie *.brd files and not *.pnt files. Either way I can help if we are talking about the same machine. Please advise and I can send you the software by email and the manuals by
Electronics Forum | Tue Mar 05 03:13:52 EST 2002 | rkey
hi, yes i know those machine'a are made by YAMAHA !! Philips sels them under a different name. i know this machine (PHILIPS, YAMAHA) uses UFO's and BRD Files! It would be great sending us the software including the manuals! Thnx alot pal. Best rega
Electronics Forum | Thu Aug 24 13:38:23 EDT 2000 | Dave F
It seems that sceening at -20�C and using a vibration profile similar to the one you mentioned does a good job of high-lighting defective solder connections on assembled boards, but not affecting good connections. Why is this happening? In there a
Electronics Forum | Wed Jun 13 21:27:41 EDT 2001 | davef
It depends on if [1] your solder connection is properly wetted or not and [2] the connection was sheared properly or not. For a properly wetted connection and properly run shear process, it looks like someone cut the connection with a knife. Consid
Electronics Forum | Wed Dec 10 16:15:24 EST 2008 | terryl
on the front end in design, minimize the pth connections to ground planes. this takes alot of work by the pcb designer and the approval of the design engineer. connect maximum of 4 ground planes to pth, minimum 1 plane. use spoked connections. ev
Electronics Forum | Thu Sep 05 21:58:24 EDT 2013 | davef
Both SN100C and SAC305 are excellent and tested LF alloy formulations that with proper process management will produce good looking and reliable solder connections. "Bright & shiny" solder connections is NOT a good measure of a properly soldered LF c
Electronics Forum | Mon Dec 12 15:51:56 EST 2022 | richardcargill
We have a BTU VIP70, but the traffic lights on top aren't connected anywhere. I've had a hunt around and can't find the appropriate connector inside, or where to connect them to. Does anyone know where these connect to please. Cheers
IPC is the trade association for the printed wiring board and electronics assembly industries.
Training Provider / Events Organizer / Association / Non-Profit
3000 Lakeside Drive, 309 S
Bannockburn, IL USA
Phone: 847-615-7100
