Electronics Forum | Sun May 22 23:31:51 EDT 2005 | thaqalain
If 1 & 2 are low, then 3 will be low: *Always *Sometime *Never
Electronics Forum | Mon May 23 08:34:20 EDT 2005 | davef
http://www.semiconfareast.com/logicgates.htm
Electronics Forum | Mon May 23 09:15:09 EDT 2005 | dougt
And Gate If one/both inputs are low, output will be low If both inputs are high, output will be high
Electronics Forum | Tue Oct 03 09:23:55 EDT 2006 | kenscj
We are encountering BGA solder open connection. At Functional Test, the board failed. Debug guy diagnosed this BGA open connection (2 locations), by using multimeter. Under 5DX inspection, there is connection. Take the board for localised reflow at
Electronics Forum | Tue Dec 07 00:13:00 EST 2004 | saiwong
I have a problem that our JOT convoyors & loader cannot connect the Fuji machine. Also, I wondered how can I get the support from JOT.
Electronics Forum | Tue Oct 03 09:36:30 EDT 2006 | Brian
Using a meter to check a BGA connection to the board, there will be other parts of the circuit involved. Sounds like a bad batch of parts.
Electronics Forum | Tue Apr 13 14:56:22 EDT 2010 | charlesyeh_wellex
Hi: Did any one know about how to connect boardFLO to Fuji CP machine? I did not have communication cable between both two machine. Thank you
Electronics Forum | Tue Dec 07 09:32:32 EST 2004 | pr
http://www.jotautomation.com
Electronics Forum | Thu Oct 05 00:48:22 EDT 2006 | KEN
What is the surface finish of the PCB? What type of BGA? What type of solder / flux are you using?
Electronics Forum | Wed Apr 21 14:38:30 EDT 2010 | remullis
Newer Universal Conveyors use 4 wire smema and FUJI should accomodate this protocol in its config screens. Old Universal Conveyors and some machines used SMPI (forget how many wires), You can purchase the 4 wire smema cable from UIC and conversio