Electronics Forum | Thu Jul 09 13:19:38 EDT 2009 | emanuel
Just in case somebody will bump in the same situation and looks for a possible solution, the problem was with a small 2 pin connector that feeds one of the W DC motors. The connector looked ok, but one of the pins pulled a little out and was making
Electronics Forum | Fri Jul 31 17:09:55 EDT 2009 | isd_jwendell
Don't know about Topaz, but on Essemtec machine using SMC ejector, there are separate solenoid valves for vacuum and release. The connectors are identical and side by side. If these connectors were swapped then I would have the symptoms you describe.
Electronics Forum | Thu Nov 05 07:05:43 EST 2009 | leeg
Has anyone come across these before? We have just started to manufacture boards with the Solder Tail Stack-Through connector and need a solution to speed up the soldering...
Electronics Forum | Thu Nov 05 20:19:05 EST 2009 | martinwuest
I would switch to Teka PC104 solder bearing lead connectors. You can reflow them along with your SMT and eliminate hand soldering. I've had a lot of experience with them and they work great. http://www.tekais.com/pc104.asp Steve
Electronics Forum | Tue Jun 28 14:06:08 EDT 2011 | dmiller
If you have room, and the aperture size will allow for it, try a 5 mil overall stencil thickness with a 1 mil step-up in the area of the BGA connector.
Electronics Forum | Tue Nov 01 10:34:16 EDT 2011 | austinpeterman
We have tried using pookie to form an air tight seal on top of the connectors without success. We have tried filling the connector with dielectric grease with some success. Havent found any info on 1-2577 in gel form. Has anyone found this product
Electronics Forum | Tue May 22 11:18:55 EDT 2012 | patrickbruneel
A picture of the top side of the connector would be helpfull too. I assume the 2 large leads in the front are part of that connector too.
Electronics Forum | Thu Sep 05 23:32:29 EDT 2013 | winson16
This connector was designed with gold flash plating and the lead's surface was become dull and some black mark was observed on the contact surface.
Electronics Forum | Thu Sep 12 08:29:50 EDT 2013 | williamaxler
In my past we have used grease that we put in the connector before potting. The grease would keep the potting from flowing into the connector.
Electronics Forum | Wed Sep 20 09:24:34 EDT 2017 | leeg
We are due to build a board with a few of the Andon Image Sensor Connectors on and was wondering whether anyone has any experience of these devices? Manufacturing guides, inspection guides and rework guides?
.png)
