Electronics Forum | Thu Dec 05 02:43:49 EST 2013 | haiae
Hi, You just take out motion board, clean it & connector on the interconnector board. After done plug in and boot the machine again, it'll be fine back.
Electronics Forum | Wed Dec 04 16:35:54 EST 2013 | martingruber
I am facing the following problem: Powering up the machine the start sequence stops with following message: Inizializing Hardware .... Reading SRAM data .... Inizializing MEI Motion Bd .... Mei bd. @ 240 # Dev. Version 2.4g2 Option 41 DSP BOOT MEMORY
Electronics Forum | Sat Jan 03 03:36:02 EST 2004 | Barney
I see on Contact Systems site there is a new machine. I have spoken to one of there c7 machine owners. I believe they are the only one. I have been told he cant get support. Has Contact decided to drop the c7? Contact only has two people in there sup
Electronics Forum | Sun Aug 07 13:12:45 EDT 2005 | Patty Chonis
Hello We sell soldering stations that can heat up to 200 celcius in less then 20 seconds. The temperature settings are variable and can be pre-programmed. The stations are very competitively priced and can handle home soldering applications. Please
Electronics Forum | Wed May 12 23:33:04 EDT 1999 | Matt
WARNING: This is a plug. I have read post on this site where the question is raised: "My machine can do 80 units per hour, but I am only getting 35 - WHY?" Well I have written w95/database code that reads FUJI output files (CPII,CPII,IP2 etc) and d
Electronics Forum | Fri Sep 24 16:01:07 EDT 2010 | dougt
I remember this problem but can't remember exactly what the reason was. It might have been the wrong pullup resistor on the MEI interface board used for the home photo on the y axis. You are right, after a couple hours the machine would work fine.
Electronics Forum | Thu Sep 23 14:39:10 EDT 2010 | markgray
What is the exact message on the screen?
Electronics Forum | Tue Nov 01 20:40:03 EDT 2011 | mikeincal
What may be happening is an early trigger of your vacuum sensors during production due to a clogged tip or vacuum line in the head. What happens during production is that the Y axis gets into position, and then the vacuum sensor input is monitored on
Electronics Forum | Mon Sep 20 06:29:27 EDT 2010 | darrenleebs
i have an old contact 3av pick and place machine that has started to display placement head position errors. the machine seems to start working if you switch it on and leave it for a couple of hours to warm up. has anybody had simillar issues with th
Electronics Forum | Thu Sep 23 11:37:43 EDT 2010 | flipit
I had 4 of these machines. They are good machines but I have seen this error often. Is the problem only on one head L or R? If so swap electronics L to R and see if it follows. You can even swap the Y motors. The items that could cause this prob
