Electronics Forum | Thu Dec 05 02:43:49 EST 2013 | haiae
Hi, You just take out motion board, clean it & connector on the interconnector board. After done plug in and boot the machine again, it'll be fine back.
Electronics Forum | Wed Dec 04 16:35:54 EST 2013 | martingruber
I am facing the following problem: Powering up the machine the start sequence stops with following message: Inizializing Hardware .... Reading SRAM data .... Inizializing MEI Motion Bd .... Mei bd. @ 240 # Dev. Version 2.4g2 Option 41 DSP BOOT MEMORY
Electronics Forum | Tue Nov 01 20:40:03 EDT 2011 | mikeincal
What may be happening is an early trigger of your vacuum sensors during production due to a clogged tip or vacuum line in the head. What happens during production is that the Y axis gets into position, and then the vacuum sensor input is monitored on
Electronics Forum | Sat Jan 03 03:36:02 EST 2004 | Barney
I see on Contact Systems site there is a new machine. I have spoken to one of there c7 machine owners. I believe they are the only one. I have been told he cant get support. Has Contact decided to drop the c7? Contact only has two people in there sup
Electronics Forum | Fri Jan 30 16:49:21 EST 2004 | Mike Zadrejko, Videotek, Inc.
Barney, We currently have 3 Contact Systems machines, (1) C3AV and (2) C3AVXs and I can't say enough good things about the machines or the support. It has always, always been there since we started dealing with them in 1991. The Service Dept personn
Electronics Forum | Wed Jul 02 01:59:23 EDT 2014 | haiae
Yes, I can share you my expriences about Contact SMT placement machine. Just drop a message I'll help you to solve your problems.
Electronics Forum | Mon Jun 25 20:51:43 EDT 2001 | davef
Well, the paste must be OK, because other components don�t have this problem. The board must be OK, because other components don�t have this problem. So, it must be either the component or the profile. I�d speculate that you need to do some work t
Electronics Forum | Thu Jun 19 12:18:45 EDT 2014 | haiae
There are two IR sensor (one for tipdown detector and other one for tipup detector) for each tip in each head. You should check infrared sensor for Head2 tip1, that cause may be by dirty between IR emitter and IR receiver. Just clean it and try to ru
Electronics Forum | Tue Aug 10 05:32:42 EDT 2004 | praveen_madaan@jabil.com
Hi, Has any body experienced the problem of poor cotacts on HDMI connectors. The connectors pins are gold plated and we see some kind of white residue on the gold pins.How to check if this is a flux residue?We are using No Clean flux in wave solderin
Electronics Forum | Tue Jul 01 20:39:45 EDT 2014 | chantel
Thanks so much. That was definitely the issue and I was dealing with an issue of the tip not picking up some of the parts. Then, today found out a piece of dust ball was in the vacuum and was able to blow it out, by means of deduction from the sensor
