Electronics Forum | Tue Nov 23 15:37:30 EST 1999 | Rob Horowitz
Give Contact Systems a call. A standard Contact machine will fit boards as large as 26" x 18", and place parts at a rate of 13,000 CPH. They have both new and refurbished machines to fit within your budget. I would certainly not recommend going less
Electronics Forum | Tue Feb 23 11:29:18 EST 1999 | Bill
No salesmen please. (I didn't use my real email address) I would like to know if anyone is using either of these SMT machines and if they are what input can you give me on them. We are looking at the Contact 3Z and the Multitroniks DHM for our low
Electronics Forum | Fri Apr 05 17:46:06 EST 2002 | franciscoioc
I own 3 CS-600 locator machines and need to calibrate one of them but I don't have the calibration grid.I contacted CONTACT SYSTEMS the manufacturer and they said they don't support this machines any more. Does any one have a calibration grid for thi
Electronics Forum | Thu Apr 29 01:55:27 EDT 2004 | Frank
Contact your manufacturer of the machine and see if the belt feeders are available. Comtra Systems is the maker of the belt feeders and I do not know if they sell direct to the end-user. I don't have any contact information for them. I know they
Electronics Forum | Thu Sep 07 10:13:42 EDT 2006 | davef
Contact peel force equipment manufacturers, tell them what you want to do, and ask them for the contact information of their customers in your region. Some prominent peel force equipment suppliers are: * RVSI/Systemation TP-150 * EPI PTS-2001 * GPD
Electronics Forum | Thu Nov 20 08:10:35 EST 2008 | wanderson
Hi All, Can someone find out for me the cost of a spare part for the Contact3Z platform in the USA for me please? The part no is 3Z-M06-01-14. It is the bellows that fits onto the end of the tool spindles. In the UK we are being quoted a redicul
Electronics Forum | Tue Sep 04 13:23:10 EDT 2012 | jvoytovich
I've got an older (90s?) Contact 3Z system with a bad Falcon vision card. The CPU refuses to even enter the BIOS (or display anything on the monitor) with the card plugged in, but boots normally with it out. I'm looking for any advice on a replaceme
Electronics Forum | Fri Nov 14 12:41:30 EST 2014 | duoman
I also operate a 3/45. In order to flux from the top, you would need to have another system on top similar to what you already have on the bottom. There just isn't room for all of the required equipment. Who did you contact at ERSA? I have always had
Electronics Forum | Tue May 15 04:15:36 EDT 2018 | godless
After reinstalling software, i get message when loading printer: "A printer file could not be opened, therefore the printer cannot be started. Please inster your calibration diskette and press confirm. or contact or contact DEK customer support. Pres
Electronics Forum | Wed Apr 08 17:42:24 EDT 1998 | Wayne
| For nearly 30 months I have waited on Contact Systems | resolving indexing and clearanceproblems with their | 32mm and 44mm tape feeders. I think that the service | that they offer is pretty poor. | Am I alone? Does anyone else use their larger
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400