Electronics Forum | Tue Nov 20 08:15:36 EST 2001 | John S
Dave, How do you try to contol the glue release? The information we've gathered so far indicates that this is controlled by the speed and distance of stencil separation. How do your defect levels compare to dispensed products? Thanks again, John
Electronics Forum | Mon Nov 22 05:22:29 EST 2004 | Rob
Hi Harry, We had some of the ECU's, but all they are is a heater & a chiller, and the controller turns on whichever one is required. Unfortunately the contollers were pants so our lab made their own. Rob.
Electronics Forum | Sun Jun 25 00:33:13 EDT 2000 | Robertsam
I had problembs with taping the signal to on the buzzer with machine tower light.However I try to connect parrallel to the light but the control board which connected to the light malfunction after 1/2 hour.The tower light is trigger by the ground s
Electronics Forum | Thu Apr 16 08:07:05 EDT 1998 | Stan
Currently I am in the buisness of soldering bare die to the top surface of a copper heat sink. Is any one else have some exprience in this process that can help. We heat a copper slug through a contolled atmosphere, place a preform then a bare die.
Electronics Forum | Thu Jul 15 22:19:04 EDT 2004 | KEN
Yep, but its hard to contol small parts with the bags. They're good for DIP's and sockets, connectors, but radials are kinda hit and miss. I bought mine from Pentagon EMS. They only use the finest european leather (kidding). PENTAGON EMS 10950 SW
Electronics Forum | Mon Jan 31 07:01:25 EST 2005 | EHess
Run a water-soluble mask that foams in the wash. Use a de-foamer to contol that. One or the other, or both are causing a greasy build-up that is hard to get off in certain areas. I have a closed loop DI water system. Can I use some sort of deterg
Electronics Forum | Thu Dec 08 22:41:44 EST 2005 | davef
Mike: You're correct, but in better shops there are guys with little black books in their back pocket. They know how to contol their variables and give you a good product. I worked at this plant where we cooked dirt. It glowed orange-red and flow
Electronics Forum | Tue Jan 31 11:56:12 EST 2006 | kmorris
Just wanted to take a quick poll, as to how others are taking flux density measurements on their wave solder machines.(those that don't have flux density contollers) We are using a glass hydrometer, but I see there is a digital model on the market.
Electronics Forum | Mon Nov 06 11:26:09 EST 2006 | Rob
I''m sure I remember BTU telling me that the VIP series got the same contollers as the ancient TRS14's. Someone may want to verify this - but if correct you can pick up a TRS for beer money & rob the controller. A new 7 zone BTU Pyramax can be ha
Electronics Forum | Fri Feb 24 09:24:08 EST 2012 | bobpan
1. You should be running the machine from the computer and central contoller. (not the handheld or run button on machine) 2. What is the tep commands in your sequence steps....I think you need to have tep vision as the first step and tep vpass at the
.gif)
