Electronics Forum | Mon Feb 12 06:02:14 EST 2007 | mk
I think Mark may be able to help you out. Mark Strickland Marshal Space Flight Center MFSC Huntsville AL PO Box 707 MS K68 Huntsville, AL 35812 256-544-7432 mk
Electronics Forum | Mon Feb 12 12:07:19 EST 2007 | john_smith
Brian, I would love to post them on equipment mart but do you really think they would sell?
Electronics Forum | Mon Aug 16 20:19:10 EDT 2004 | Grant
Hi, We have both Vapor Phase ASSCON semi auto as well as Soltec convection inline ovens. I must say we had no end of problems with Vapor Phase. We tried everything, and just could not totally eliminate tomb-stoning completely. We would always get a
Electronics Forum | Mon Feb 23 14:44:08 EST 2009 | sunny
Are boards produced using Vapor phase ovens dirtier than N2 Reflow oven. Are there any studies/papers someone can point to? if not what are the methods to verify this? is IPC specified SIR test using 24B SIR test coupons? please advise. thanks in adv
Electronics Forum | Wed Aug 18 00:53:16 EDT 2004 | Grant
Hi, I think you cannot go wrong with Convection. If you want to experiment with VP, just get some of the fluid and put it into a pasta cooker on a standard domestic hot plate. Have a basin full of cold water so after reflow you can lift the cooker a
Electronics Forum | Wed Sep 17 04:15:23 EDT 2003 | C Miller
The magnetic thing from the sot23 thread made me think of somthing from the past. Does anyone have any experience with vibrating boards during reflow? I know for a fact that if you vibrate a board during reflow it will alow the parts to "float" and
Electronics Forum | Wed Mar 19 20:40:27 EST 2003 | arminski
Vapor Phase process can do reflow from 4 to 5 times!
Electronics Forum | Fri Mar 21 20:21:41 EST 2003 | Grant
Hi, I can verify that, and we have done 2 or more reflows with prototypes, using vapor phase reflow, and because there is no oxygen, the result is good, and you cannot tell the difference between the first reflow, and the 3rd. We are getting a vap
Electronics Forum | Fri Mar 29 11:02:04 EDT 2019 | robl
Not sure it's always a great route as the smaller ovens are going to struggle to get a perfect profile for a consistent result, especially on bigger boards with higher layer counts and mixed technology. You may want to take a quick look at a batch va
Electronics Forum | Mon May 01 23:23:58 EDT 2006 | grantp
Hi, I off center idea we used when we started. Get a pasta cooker, and put in vapor phase fluid, and then use that. Place the product in the bottom of the inner pot, and then heat on a small hot plate. When the vapor cloud gets high enough and the