Electronics Forum | Fri Dec 03 12:16:58 EST 2010 | vmorina
Hi Jack, I haven't progressed that much on the reflow project.I'll be working on it in two weeks. Although, I have few vendors that I've been communicating for more info about vapor phase reflow ovens. See the following list: Wenesco Sintronex AICT
Electronics Forum | Thu Jun 12 08:35:25 EDT 2014 | jax
I don't fully understand what you are trying to do... 1. Reflow Solder in a Vacuum Temp Chamber 2. Vapor Phase / Condensation Solder with Vacuum 3. Contact Heat system with Vacuum 4. Inline Reflow Oven with Vacuum ... or what you are trying to sold
Electronics Forum | Thu Jun 12 09:42:06 EDT 2014 | spitkis2
I am looking into Vapor Phase with Vacuum and Inline Reflow with Vacuum (besides Heller I believe a German company SMT has something comparable). There are a couple of companies I found that make vacuum ovens for soldering of hybrid microelectronics
Electronics Forum | Wed Mar 06 11:02:07 EST 2002 | slthomas
I worked for a medical instrument manufacturer a few years ago and we had to calibrate all measurement devices. That included everything from our vapor phase oven's thermocouples to 6 inch steel rulers. I don't see any logical justification if you'
Electronics Forum | Wed Sep 03 18:20:00 EDT 2003 | davef
Major advance: Productionization of SMT. Minor advances: * Realization and control of solder paste characteristics * Vision alignment controls in printers. * Evolution from mechanical centering [through laser alignment controls] to vision alignment
Electronics Forum | Mon Nov 07 11:26:23 EST 2005 | CW
How large of chip capacitor can we use reliably? I��ve heard they tend to crack. I��ve also heard if you pre heat the larger chip caps (1812 and above) before vapor phase reflow, they won��t crack. If I use 2 mil copper for a power supply board, a
Electronics Forum | Wed May 12 11:55:08 EDT 2010 | pbarton
We are using VPS, but only for high mass assemblies. As the other respondent has suggested if the mass of the assemblies is very low then difficult to control temp. rise times to within the normally accepted parameters. The Rehm equipment does seem
Electronics Forum | Wed Nov 17 05:20:38 EST 2010 | jlawson
Also please contact Rehm Thermal, they make best Vapor Phase systems in terms of cost of onwership - less galden usage than Asscon or IBL, have more controllable ramp rate control vs the other vendors also...use patented galden injection on demand an
Electronics Forum | Wed Jul 05 01:22:29 EDT 2006 | grantp
Hi, When I started out and we were the same we got an old MYDATA TP9-2U. It places everything, and you should be able to get a cheap one second hand, that will perform very well. They have vision as well, as an options, and that works very well. I w
Electronics Forum | Thu Aug 27 13:14:49 EDT 2009 | ghepo
I have already told you that is not possible solve this problem by e-mail, without perform a detailed failure analysis. Also I have told you to procede by exclusion. Are you sure, by tests, regarding the PCB quality ? Are you sure regarding the solde