Electronics Forum | Thu Jul 25 16:20:59 EDT 2019 | bobpan
Top red led is on or off depending on version of tep board. The green leds light when the transport sensor that it communitcates with is seeing a board over it. Tep controller init failure can be one of the following. 1. Check reseat tep card and
Electronics Forum | Tue Aug 06 16:49:57 EDT 2019 | jmedernach
HI, The short answer is, "whichever machine finds your defects." I would suggest evaluating machines based on a common vehicle. Make a bad board and identify the defects. Make a good board and have your vendor teach and tune the machine to the goo
Electronics Forum | Tue Mar 17 16:27:32 EDT 2020 | sportsradar
With LC off, the machine when told "Without LC" will zero set. It displays Error 746. After zero set, turn LC on, and it hangs up. Error 746 is IEC blocked, solutions Reboot machine and PC. And we know, rebooting isn't getting me anywhere. What car
Electronics Forum | Wed Mar 18 18:22:32 EDT 2020 | sportsradar
I have replaced both cards on the machine and the card in the PC. I have also replaced the cable. I can see where the machine is sending the request for data (by the screen shoots above). And I can see the PC is seeing something from the machine by
Electronics Forum | Tue May 26 23:42:20 EDT 2020 | smiran082
Hello, I am having trouble the QSV-1 PNP machine. On boot it had trouble connecting to the RT computer as it was hung on a message saying something along the lines of, "Establishing connection to RT computer". After several restarts we still could
Electronics Forum | Wed Jun 03 21:49:27 EDT 2020 | bboyer
Well, we finally got the machine to power up and fully boot, but now we are having issues with zeroing the axes. X, Y and Theta zero OK, and the board conveyor runs, but when it tries to zero the PWC, the rail moves to the rear of the machine, hits
Electronics Forum | Mon Aug 31 11:52:28 EDT 2020 | inspiredmorris20
Hello Jon, I appreciate your reply, correct there are 2 red (24v) that control the main power and 2 blue (they control the power to the units operation keys ready, start, stop, reset, change feeders.) additionally there is a red jumper wire on the E
Electronics Forum | Thu Oct 29 16:22:42 EDT 2020 | spoiltforchoice
The software is crazy expensive for some of this stuff and in many cases you could develop the bits of it you actually use in-house for a fraction of the cost. Unless you are a company who really like this level of process control and you run multip
Electronics Forum | Wed May 19 20:11:21 EDT 2021 | compit
I have two machines - Emerald-X and Topaz-X. I cleaned (and changed Koganei electromagnets) only in Topaz-X - Emerald-X is in very good condition :) But my Emerald-X have SF (not FNC) heads. If head 1 is OK - change the relays with head 2 and check.
Electronics Forum | Thu Jul 01 19:13:48 EDT 2021 | SMTA-64387161
Welcome to SMT! I highly recommend exploring the process of adding unique reel identifiers to your reels and tracking locations, or even kitting, using these barcodes. You may also see this referred to as serializing or license plating. Implementin