Electronics Forum | Fri Mar 05 08:06:39 EST 2010 | rgduval
Rob, Had that issue early on when we hooked up our Heller. For us, the problem turned out to be the serial communications port on the computer. I can't say we had the black screen, but, we had comm errors. I'd check the following: 1. Cable betwe
Electronics Forum | Tue Apr 18 12:03:30 EDT 2023 | dskling
No. they struggle to move a little but not a full cycle. We have replaced the 3 control boards on the back door, both EMI filters, check and replaced all fuses, pulled the clinch head and swapped it with another working clinch head and that blew a c
Electronics Forum | Sat Oct 10 02:59:53 EDT 2015 | aemery
AVCOM, I have worked on a few of the Conceptronic ovens recently for one of my clients. They had a similar issue, all the heaters dropping out with a high temp circuit error which kicks out CON1 (Heater power). If you're saying what I think your sa
Electronics Forum | Thu May 17 03:52:34 EDT 2007 | kevinjm
Hi lads, I have a problem with asequencer 2596. We had a power cut last week which cut power to the seq. The battery on the controller box was dead(now replaced), which meant the exec file got deleted from machine. Now I can't load it back up again.
Electronics Forum | Fri Apr 27 09:05:51 EDT 2018 | dszewczak
prompt) When we came back in the morning it was repeat scrolling an "ODD ADDRESS ERROR" on the monitor. I used a loopback to verify that the serial connections were good all the way to the control box. We tried uploading the main program to the ma
Electronics Forum | Fri Sep 14 10:53:25 EDT 2012 | mili
In Setup menu there is a last option Debug. Debug choosing a window with Rack0, Rack1, Rack2, Rack3, log RS485 opens. Choosing rack0 a window with parameters S3 boxes 1 to 12 Input and certain boxes are checked, S4 Output from 1-8, from 1-8 S5 Outpu
Electronics Forum | Fri Aug 28 17:47:59 EDT 2020 | inspiredmorris20
thanks Stephen!! I'm testing for voltage and have found 24v going through the E-stop to the main switch. If i trip the E-stop i can disengage the main switch. I have no more control to the hardware then that. The software is not throwing any code ot
Electronics Forum | Thu Oct 25 19:53:42 EDT 2012 | sonavc
Thank It worked without the user name and password.When I try to zero axis I have other error unable write to global memory 5008. My machine, when turn it on i don't see the power to the Digiplan 8 axis modular and no bright on 24VAC on at servo co
Electronics Forum | Sun Jul 18 12:13:06 EDT 2021 | oriolsancheza
Hello, Our machine started to not stopping board into the right position (stop pin was not working we guess). After some inspection we have not seen anything strange. However the DEK software decided to not work anymore. We've been messing arrounf
Electronics Forum | Sat Jul 19 12:07:46 EDT 2008 | operator
I have alot of experience creating assembly drawings for SMT and THT products. However, we are now doing very large ,complicated box builds that have many terminal blocks, point to point and cable harnesses. It is my job to create these assembly doc
