Electronics Forum | Tue Aug 31 20:06:12 EDT 2004 | adiaz
Hello All, We have our MPM AP25, S/N: 6791 down due to problems with the following cards: - P1280 - Digital Motion Controller - PC101 - Motion Interface Board These boards are obsolete and are not in stock, we would like to know if you may have th
Electronics Forum | Wed Jul 21 10:38:10 EDT 2021 | bukas
I got Samsung CP45FV NEO with Cognex 1063200006110P single board computer. This machine had about 10 data corruption problems in past two years on both classic ATA and industrial ATA SSDs. I suspect there may be something wrong with Cognex card and t
Electronics Forum | Tue Aug 07 08:43:59 EDT 2018 | joycehughes
Does anyone have one, or know where we can find one?
Electronics Forum | Mon Oct 05 08:32:11 EDT 2009 | jeffharley
Make sure you have DC ok light on, on the EMI/PS card slot one. If not check your DC voltages at the card...5,15+,15-,12 v dc. if your voltages are not there then the machine will not run.
Electronics Forum | Sat Oct 03 01:44:56 EDT 2009 | slthomas
Doug is on to something there, but you may still have other problems. It could be your exec. is corrupt and needs a reload (I sound like a certain UIC tech. support dude) or you could have a hardware problem. Do you vacuum that thing out with any f
Electronics Forum | Thu Mar 05 23:04:44 EST 2020 | sarason
My advice for what it is worth. Your description of the problem at first glance suggests a communication problem, now is it the bus, the SMT machine or the PC. The bus could have a short or an open. The PC could have a dud controller card. or so co
Electronics Forum | Mon Mar 16 12:10:59 EDT 2020 | emeto
Katrina, it is one of both: 1. Communication error - try to initialize machine with line controller OFF. This should tell you if machine can initialize on its own and if the problem is on the machine. Try without the feeder carts, look at the cards
Electronics Forum | Wed Mar 18 16:15:49 EDT 2020 | emeto
Katrina, if the machine will zero on its own, there is nothing wrong with machine itself. You can now look into network cards in both line computer and line PC.
Electronics Forum | Tue Mar 17 16:27:32 EDT 2020 | sportsradar
With LC off, the machine when told "Without LC" will zero set. It displays Error 746. After zero set, turn LC on, and it hangs up. Error 746 is IEC blocked, solutions Reboot machine and PC. And we know, rebooting isn't getting me anywhere. What car
Electronics Forum | Wed Mar 18 18:22:32 EDT 2020 | sportsradar
I have replaced both cards on the machine and the card in the PC. I have also replaced the cable. I can see where the machine is sending the request for data (by the screen shoots above). And I can see the PC is seeing something from the machine by
winsouce.jpg)
.gif)
