Electronics Forum | Fri Feb 25 05:42:17 EST 2000 | Istv�n Dominik
Hi, We should wavesolder a PLCC44 package. The PCB is under the design procedure now and we must specify the best parameters (the orientation (45 or 90 degrees) of the package on the PCB,the number, the positon and the size of the solder thief pads
Electronics Forum | Fri Feb 25 05:42:17 EST 2000 | Istv�n Dominik
Hi, We should wavesolder a PLCC44 package. The PCB is under the design procedure now and we must specify the best parameters (the orientation (45 or 90 degrees) of the package on the PCB,the number, the positon and the size of the solder thief pads
Electronics Forum | Sun Nov 15 23:40:59 EST 1998 | emori
Our design team is trying to change QFP into BGA. Does anyone have experience wavesoldering PCB with 0.5" pitch BGA's on the top side? What kind of problem will occure? Any advice is appreciated.
Electronics Forum | Fri Feb 25 16:10:11 EST 2000 | Dave F
Russ: You're correct, running second side SMDs on the wave without adhesives is more fun than a lot of people think. Ta. Dave F
Electronics Forum | Fri Feb 25 16:10:11 EST 2000 | Dave F
Russ: You're correct, running second side SMDs on the wave without adhesives is more fun than a lot of people think. Ta. Dave F
Electronics Forum | Fri Feb 25 11:13:32 EST 2000 | Russ
This probably won't help much but I find it at least a little interesting. During some experimentation recently I accidently loaded a board into the wave upside down and it had a PLCC 68 package along with other types of components that had only bee
Electronics Forum | Fri Feb 25 11:13:32 EST 2000 | Russ
This probably won't help much but I find it at least a little interesting. During some experimentation recently I accidently loaded a board into the wave upside down and it had a PLCC 68 package along with other types of components that had only bee
Electronics Forum | Wed Oct 06 09:40:49 EDT 1999 | Mark Quealy
I have an adhesive dispenser in my workcenter but I rarely use it. I've replaced this process with wavesolder pallets for bottom side PTH soldering, ocassionally gluing parts left exposed by the pallet. So I was thinking of selling the dispensing equ
Electronics Forum | Fri Feb 25 16:06:51 EST 2000 | Dave F
Istv�n: Given a choice, I�d run second side PLCC44s at 90� to the wave. As far as thieves are concerned, I�d have two, mirror images of each other. Unlike most, these thieves are not connected to pads. They are out-side of the last pad on the sid
Electronics Forum | Fri Feb 25 16:06:51 EST 2000 | Dave F
Istv�n: Given a choice, I�d run second side PLCC44s at 90� to the wave. As far as thieves are concerned, I�d have two, mirror images of each other. Unlike most, these thieves are not connected to pads. They are out-side of the last pad on the sid
winsouce.jpg)
