Electronics Forum | Wed Jun 07 23:57:22 EDT 2017 | marcelll
Hi, Try to find replacement edge belt pulley for old PCT conveyor. Any idea where to find a supplier to buy small pulley for 1/4 inch edge belt ? Thanks
Electronics Forum | Tue Feb 15 03:56:18 EST 2022 | cbeneat
Is the wheel that drives the belt in alignment? I assume all the bearings are turning. We've had bearings in the past be on the edge of seizing in our end pulley's. Tightening too much could cause it to turn harder, causing the belt to jump off. Coul
Electronics Forum | Tue Feb 15 20:42:06 EST 2022 | jdengler
I think it is the belt. Looking at the video it appears to come off just after the splice goes around the pulley, so probably a bad splice. Jerry
Electronics Forum | Sun Oct 16 04:23:20 EDT 2005 | olas
I have a couple of questions about the SMEMA conveyor (standard 1.2); I posted the question to them but had no answer. SMEMA says: 5) Maximum gap. The maximum gap between the in-line machine track ends is 0.375� I would suppose this gap refers to th
Electronics Forum | Tue Oct 09 11:42:42 EDT 2012 | cyber_wolf
Actually the correct way to fix this is to carefully remove the belt on the rear of the machine that connects the left and right rail lead screws together. Square the rails then carefully re-install the belt *without turning either of the lead screws
Electronics Forum | Wed Sep 26 07:40:30 EDT 2012 | highmillr
I had this problem at another plant with the UP 2000....When the machine resets, The left and right side of the conveyor misaligns, causing the conveyor to be tight on the loading end and boards falling out of the unloading end. or vise versa...the t
Electronics Forum | Wed Feb 08 09:21:03 EST 2012 | ngineer
What Should I use to clean a sticking conveyor > belts in my pick an place machine (Quad IVc)? > The belts seem to have what I would guess to be > solder paste that is dried, but also they seem to > be a bit gunked up as if they had gotten some o
Electronics Forum | Wed Jan 17 07:58:31 EST 2018 | lokiz
Greetings, I have been told that auto rail width with the Samsung SM320 is a purchased option opposed to a standard feature. What I would like to know is what all comes in the auto rail width kit. It looks to me like the wire harness where the rai
Electronics Forum | Sat Aug 24 08:01:28 EDT 2002 | kumarraju
Hi CS Tan, Most customers expecially tend to neglet maintenance of the machine. As in the case of Dek 288 most of the end users have the impression that the 288 is one of the worst machines by Dek. But till today although Dek has discountinued manufa
Electronics Forum | Mon Jun 10 10:12:42 EDT 2019 | assuredtech
What is the year, make and model of your oven? Are you running it with Upstream and Downstream (pre-reflow, post-reflow) conveyors? Is the qty of the product low, medium or high? What is the max process width of the oven? what is the max board with o