Electronics Forum | Thu Dec 17 09:34:05 EST 2009 | pfifla1
does anyone know of a place to purchase a kit to repair or make replacement belts for PCB conveyors? it would be convenient to make vs. repair. they are just the standard rubber conveyor belts.
Electronics Forum | Thu Dec 17 12:23:46 EST 2009 | leemeyer
Take a look at http://www.habasit.com. They supply tooling to make these belts. I found it more cost effective to have the belts made for me at a local belt supply buisiness, the tooling is expensive.
Electronics Forum | Fri Apr 08 05:11:12 EDT 2011 | diputechem
you can use Rema tiptop's repair kit. if you think rema brand is very expensive. can use these tools made in China. The conveyor belt repair tools made by Dipute Co.,Ltd. is with good quality,low price,they have good reputation in Asia,and gained hi
Electronics Forum | Tue Jan 05 09:46:45 EST 2010 | cyber_wolf
Use these guys. They 5 out of 5 stars. http://www.vossbelting.com/flatconveyor.cfm
Electronics Forum | Wed Jan 20 04:21:11 EST 2010 | josh_brubaker
If it's just a break, you can easily glue it with a 2-part glue from Coolchem.com Look for the Integrator 75 and Activator 310. I was surprised at how well the glue holds up. This is one of those mystery products where the repair becomes stronger th
Electronics Forum | Mon Jan 04 21:10:39 EST 2010 | cbart
Having them made by a local supplier is the fastes cheapest and most accurate way to get replacements when the manufacture no longer supports. If its broken and you need it ASAP I have used spider wire (fishing line) to mesh back together. laugh all
Electronics Forum | Fri May 05 03:38:02 EDT 2023 | ttheis
I am looking for some parts to repair a dyna-pace 1 meter conveyor if anyone has a scrap unit laying around. We just need the sheet metal edge strip as shown in the attached photo. Also looking for width adjust handles and a source for the 10mm wide
Electronics Forum | Fri Oct 23 14:58:40 EDT 1998 | Dave F
| We've got a continous flow cooling problem from our wave solder process into ICT. Our current configuration is a flatbelt conveyor into a manual de-pallet process, operator then places on to an edge conveyor. We've tried muffin fans, look good bu
Electronics Forum | Wed May 30 19:08:58 EDT 2007 | darby
Mark, You should find that the blower motors and heaters will be replaced free of charge by Heller. I have four Heller ovens and have found that to be the case. I am the original purchaser however and it may be different if you have purchased the mac
Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
