Electronics Forum | Mon Sep 12 09:26:00 EDT 2016 | awhite
Our MPM Up2000 HIE is having a communication problem with any upstream machine we place in front of it...i.e. conveyor, board loader, etc. It all started when we removed a conveyor from inbetween it and a board loader, and hooked those machines up di
Electronics Forum | Fri Jul 22 18:22:36 EDT 2011 | garym4569
We have a inline YesTech YTV-2000 in a newly configured SMT line and having issues with the transfer system. Shortly after the unit is put in run mode, the conveyor will turn on and run as if it is attempting to load a pcb even though no pcb availab
Electronics Forum | Thu Sep 02 20:41:03 EDT 2010 | mmccance
SME, Thanks for your response, but I have already checked out 1 & 2 on the downstream conveyor, and they are sending the machine ready signal. I know that the loader is recieving it because when the downstream conveyor is not busy the loader attemp
Electronics Forum | Tue Nov 03 22:11:38 EST 1998 | phillip hunter
| SMTnetters: | | My UIC conveyors aren't working with my: | | �Omniflow 7 Reflow (Mfg 1/95) | �Dek 265 GS | �Philips CSM | | | What can I do? Does anyone have experience with connecting UIC or other conveyors to the above equipment? On the refl
Electronics Forum | Thu Jul 23 13:23:45 EDT 2020 | bmalhi
Small components blown issue could be due to one of the below. - Process issue; Make sure solder paste is fresh, if flux is drying out it will not hold parts properly. Check downward pressure of Pick Place. SOT may have to be pushed a little harder i
Electronics Forum | Fri Jul 17 10:50:49 EDT 1998 | Rob
| Howdy, | Is anyone using Seho? Need to know more about 7000 series machines with nitrogen and ultrasonic fluxer capabilities. Any shortcomings (I can't see them)? What are the positives, beside those obvious? | Earl Moon I have a 7240n2-F. I have
Electronics Forum | Thu Jun 25 14:33:51 EDT 1998 | Chry
| Hi there Chris! | Are the leads you talking about fine pitch? Is the complete fillet attached to the foot, with it being cleanly separated from the pad? I bet if you look at the board there will be via's really close to the pads at the location
Electronics Forum | Mon Dec 17 09:15:57 EST 2007 | kpm135
I have personally worked with MYData, Quad, and Panasonic in the past. We are a High Mix, Low Volume CM. The plan that is in the works is to use the CP6 to place all chip components and then use our MYData TP9 or MY12 to place the rest of the compone
Electronics Forum | Fri Jun 26 15:37:50 EDT 1998 | Justin Medernach
| | | Alright gentlemen and ladies of the forum, I again seek knowlage on what is probably a well known fact. I have spent a good part of the morning with various IPC standards and weighty tomes such as the Electronic Packaging and Interconnection H
| 1 |
