Electronics Forum | Mon Feb 26 11:10:59 EST 2024 | clpassoni
When the pick&place is at speeds above 80%, the X driver displays error 21, at lower speeds (
Electronics Forum | Wed Jan 17 21:19:08 EST 2007 | Jnet
I believe the drive of the conveyor whether rail or belt is the same so the sprocket choice in the software would effect belt or rail conveyor speed. I would make sure the number of teeth match the sprocket selection in the software.
Electronics Forum | Wed Aug 01 11:22:25 EDT 2012 | davemac62
ERROR: "The specified i/o operation on DeviceHarddisk0Partition01 was not completed before the timeout period expired" This is followed by out of control conveyor speed and zone temps. Oven recovers when the error is acknowledged. This is happenin
Electronics Forum | Mon Jun 13 11:48:33 EDT 2005 | CMiller
We got a F04 error (internal Memory fault) on the shared drive and entered 8 in location N001 as per the maint manual and cycled the power. I then set all the locations listed in the manual to thier default settings. Now the motors do not run to thei
Electronics Forum | Mon Aug 30 17:21:46 EDT 2021 | jamesatqkits
So it was the drive, I was able to swap the conveyor drive for the mirror drive, these 2 drives are the same luckily. Just tapping lightly on the head would cause a 22 error to appear on the drive, at first I thought the motor must be bad. After talk
Electronics Forum | Thu Jun 19 23:46:12 EDT 2014 | edriansyah
Hi Evtimov. Yes, correct it is not a race, but I want to know the experience of those who have achieve high speed. Because I ever read some study that mentioned the optimum slope (from room temp to peak temp) is around 1.5°. If I calculate this corre
Electronics Forum | Tue Dec 27 10:18:03 EST 2016 | anhsang38
Dear Pro, I want to confirm with you about conveyor speed. is 1m/s? We are using wave soldering but it is 1.2m/min, min not second. Pls, check it agian. The flux is not relative this error. It is relative no sodering, bridge. The solder bar is the
Electronics Forum | Thu Jul 20 14:07:23 EDT 2000 | JohnW
Mike, we use carrier's as a matter of course on all wave products, it let's us keep the conveyor width the same all the time so speed's up change overs and eleimiates one more thing that can be set wrong. The main aim of the exercise is to be able
Electronics Forum | Wed Feb 28 19:48:11 EST 2001 | davef
If we were talking about a single board problem, we�d be thinking about the laminate, but since you imply the problem is broad-based across multiple assemblies, consider the following machine parameters: * Crank-up preheat time / temperature to driv
Electronics Forum | Thu Jan 04 15:39:49 EST 2007 | realchunks
Is it a failure or a schedule overdue? If it's a failure check the vacuum sensor in the exhaust. You should be able to locate the straw and follow it back to the diaphragm. You can adjust the diaphragm. Or you can electrically jumper past it.
.gif)
