Electronics Forum | Wed Nov 02 12:49:59 EST 2005 | Olas
Thank you for the advice, Mika. My question however was not generated by a practical problem, but rather from the fact that we have to design an equipment which must interface with other conveyors. By now we�ll ignore those two points. Regards, Ola
Electronics Forum | Wed May 12 07:34:42 EDT 2004 | RLeonard
The standard machine is set from the factory at 7-9 degrees, 7 is the most standard, why are you considering the change? before doing any thing to the machine, first identify why? what type of defects are you seeing? I have found, depending on the t
Electronics Forum | Wed Jul 15 03:17:47 EDT 2020 | wellmanrau
We have been producing the SMT machines and intelligent equipment for many years, integrated Design, R&D, Production, Sales and Technical Service. What products we manufactured are: SMT Printer/Stencil Printer/Solder Paste Printer, Pick and Place Mac
Electronics Forum | Thu Jan 22 20:10:19 EST 1998 | Raymond
I have the following questions with regards to the solder printing stencil design : 1) Is the Electro-polish process recommended for laser cut stencil ? 2) Should the aperture walls be slanted at an angle or straight wall, i.e. trapezoidal openin
Electronics Forum | Mon Feb 23 21:27:20 EST 1998 | fxb
| I have the following questions with regards to the solder printing stencil design : | 1) Is the Electro-polish process recommended for laser cut stencil ? | 2) Should the aperture walls be slanted at an angle or straight wall, i.e. trapezoidal |
Electronics Forum | Tue Jan 27 08:08:51 EST 1998 | Jon Medernach
| I have the following questions with regards to the solder printing stencil design : | 1) Is the Electro-polish process recommended for laser cut stencil ? | 2) Should the aperture walls be slanted at an angle or straight wall, i.e. trapezoidal |
Electronics Forum | Mon Jan 26 08:58:05 EST 1998 | Mike McMonagle
| I have the following questions with regards to the solder printing stencil design : | 1) Is the Electro-polish process recommended for laser cut stencil ? | 2) Should the aperture walls be slanted at an angle or straight wall, i.e. trapezoidal |
Electronics Forum | Thu Sep 23 22:31:25 EDT 1999 | Dave F
| | i'm sure everyone has run into this at one point or another. I have a thin pcb .025 that is single up that has to be built on a pallet. does anyone have any tricks to the pallet design that will help to hold these boards down during the scree
Electronics Forum | Wed May 09 10:40:10 EDT 2001 | davef
First, your primary side component pads should be designed according to SM-782A, "Surface Mount design & Land Pattern Standard". Next if you did that and your secondary side component pads are the same size as your primary side components, your diff
Electronics Forum | Sun Feb 15 10:47:16 EST 1998 | SMT-ASSY
In reference to your Email response, we will propose to you in the next few days a course curriculum which we hope you will find of great interest. As we told you we offer courses for assemblers and techs in PTH, SMT soldering, SMT full process using
