Electronics Forum | Tue Jul 11 21:41:51 EDT 2006 | fordf1502004
I am looking for some help and/or guidance. Our company is currently using a panasonic MPAG3 fine pitch machine, we just recently bought a universal conveyor for the downline operation, when I plug the smema cable from the panasonic into the universa
Electronics Forum | Wed May 07 09:53:54 EDT 2008 | llaerum
We have had some trouble with our Jot conveyors and the FUJI NXT. We had to modify the JOT control circuit in order for the SMEMA protocol to work prpoerly. I am not saying that this is JOTs fault. There seemed to be an incompatibility and modifying
Electronics Forum | Sat May 07 04:28:51 EDT 2005 | grayman
try checking the speed/conveyor driver,encoder,comunication I/O Board system and lastly the program. If the driver is at fault replaced it do not repair it. If software try to load it again but make back up.
Electronics Forum | Mon Jun 13 11:48:33 EDT 2005 | CMiller
We got a F04 error (internal Memory fault) on the shared drive and entered 8 in location N001 as per the maint manual and cycled the power. I then set all the locations listed in the manual to thier default settings. Now the motors do not run to thei
Electronics Forum | Thu Feb 12 13:01:12 EST 2004 | patthemack
Thanks for your response. This is a DeHaart MPC-29. It has manual vision, no conveyor. When I bought it, only one camera was working. I fixed that, but while I was jacking with that, the electronic pressure regulator (spcjr) burned up without warning
Electronics Forum | Thu May 12 04:37:30 EDT 2005 | Rob
1) Only if it's a real enhancement, and not to fix a fault in your design. 2) No, it just has to be instinctive & accurate. 3) Barcode is fine by me, but others swear by data matrix 4) Better than 1 in 10,000 - which could be once every 5 boards.
Electronics Forum | Mon Jan 30 16:30:55 EST 2006 | GS
Hi James, it could be the problem is due to residual of cleaner media entrapped under low gap of QFP 208 and 0,5 mm lead pitch. I remember in the past we had random problems of failure at test after board wash off process (DI Water wash). We met
Electronics Forum | Thu Mar 01 21:20:47 EST 2007 | J.R.
Let's talk pin holes and blow holes. I've been here since the transistion of leaded to lead-free process started for our company and we purchased a wave machine just to keep up with our lead-free orders. we put out 500-1000 boards a day both leaded a
Electronics Forum | Fri Oct 02 01:21:08 EDT 1998 | Mike Cox
Kyung Sam, | | Justin is correct, there is definately either a board design problem or the PCB maker issue. Obviously there are many mixed technology boards built in the world so I would lean towards a design issue as the root cause. Should you or
Electronics Forum | Wed Jul 14 11:36:56 EDT 1999 | Jimmy Strain
| | | Hi All, | | | Does any one experienced the solder on gold finger after | | | reflow. Its about 5 to 8 mils diameter . | | | We'd clean the entire screen printer, mounter & reflow as well, | | | but doesn't help much. | | | | | | | | Mr Kong..
