Electronics Forum | Thu Dec 13 20:52:21 EST 2012 | davef
reflow FROM => products & services
Electronics Forum | Sat Oct 21 20:53:15 EDT 2006 | Ola
Of course. It has a dynamically programmable PLC. This means that you can program it into virtually whatever you want it to do, as long as it is within that particular conveyour specification. JOT doesn't normally give this "s/w manual" and "the han
Electronics Forum | Tue Nov 10 00:18:52 EST 2015 | ttheis
How is a board conveyor typically configured to unload into a conveyor oven if there is no downline machine to five a ready to receive signal? Do you just use a plc to activate the machine ready signal at a timed interval? Would you perhaps do the sa
Electronics Forum | Wed Dec 30 11:10:53 EST 2015 | ilavu
Tom, Mount one sensor at about 6 inch inside of the beginning of the oven conveyor and use its output as ready to accept the board signal. That 6 inch distance will give you timing and space between two boards entering in the oven. Tushar
Electronics Forum | Tue Oct 09 20:30:25 EDT 2001 | djarvis
Thank you all for your input. We didn't get the oven and if we did I decided in the short term to just turn it around and run it as a belt mesh oven - the next line we buy runs it's conveyor to suit the oven. Hi to you Marc, it's been a few years. Yo
Electronics Forum | Thu Sep 29 19:45:23 EDT 2011 | edwaterfall01
The conveyor is programmed to turn off the belts and go into an error condition after 30 seconds if the board has not passed the output sensor on the conveyor. The intent is to indicate a board jam and prevent damage to the board or belts. On convey
Electronics Forum | Mon Jan 15 13:49:09 EST 2007 | leemeyer
Hello all, I am having some trouble with the conveyor speed on an Omniflow 7 reflow oven. Recent profiling showed that the conveyor was running to slow so I calibrated the speed using the instructions in the manual. After calibration there was no ch
Electronics Forum | Fri Nov 20 00:14:23 EST 2015 | ttheis
To clarify- what I have is: 1. Manual stencil print process 2. Dynapace conveyor into GSM 3. Dynapace conveyor out of GSM into oven So what I need is a way to tell the conveyor into the placement machine to "go" when a board is loaded onto it after
Electronics Forum | Sun Nov 15 18:52:15 EST 2015 | ttheis
I presume start by having it just pass into oven as soon as it is given a board from the placement machine. If I find I need to pace the boards into the oven it seems a basic PLC would be needed? Thanks for the help.
Electronics Forum | Mon Mar 20 06:21:42 EST 2006 | AR
Have a problem with Omniflo 5 (-97 vintage) pin chain conveyor. Occasionally the conveyor stops for a second or two, then makes a slight jerk, then stops again, makes a jerk etc. Then suddenly the problem goes away only to return next day (we switch
