Electronics Forum | Tue Oct 19 13:03:16 EDT 2004 | pjc
Electronics manufacturing moving to China is not about the labor man. You all don�t get it. It�s the material, and not just the electronics material either. Plastics and metal parts costs are lower. Labor costs are the smallest component of a produc
Electronics Forum | Tue Jun 13 09:14:37 EDT 2006 | samir
As I mentioned in another thread, I've always been one to flux the living crap out of a board until the ICT guys start yelling at me, which actually did happen last week. I had a little oriental guy (an immigrant to Riyadh from Vietnam), clicking an
Electronics Forum | Mon Jun 10 10:23:47 EDT 2019 | don_julio
We started getting better reflow after rotating the pcb to locate the greater mass closer to the center of the oven. However we still leave space between panels on the conveyor to achieve a better reflow. This costs us production time. I'm simply lo
Electronics Forum | Wed Aug 07 10:38:51 EDT 2019 | slthomas
I hesitate to recommend anyone as a good source just because I haven't personally investigated it myself. There are several manufacturers of recording accelerometers....I just looked at Google and found a couple that I might call on if I was looking
Electronics Forum | Fri Dec 27 17:18:37 EST 2024 | SMTA-71155914
It sounds like the lower BGA isn’t getting enough heat during the reflow process, likely due to the upper component in the PoP assembly blocking some of the heat. First, double-check the thermal profile to make sure it matches the solder paste specs—
| 1 |
