Electronics Forum | Wed Jun 07 23:57:22 EDT 2017 | marcelll
Hi, Try to find replacement edge belt pulley for old PCT conveyor. Any idea where to find a supplier to buy small pulley for 1/4 inch edge belt ? Thanks
Electronics Forum | Thu Jun 08 08:05:22 EDT 2017 | dleeper
A couple of places to try: https://us.misumi-ec.com/ or http://www.sdp-si.com/
Electronics Forum | Sun Oct 16 04:23:20 EDT 2005 | olas
I have a couple of questions about the SMEMA conveyor (standard 1.2); I posted the question to them but had no answer. SMEMA says: 5) Maximum gap. The maximum gap between the in-line machine track ends is 0.375� I would suppose this gap refers to th
Electronics Forum | Mon Mar 27 11:24:59 EST 2006 | mac
Had similar issue with Omniflow. Was actually jostling tall electrolytic caps off of pads. Found that idler sprockets/pulleys needed lubed.
Electronics Forum | Tue Oct 09 11:42:42 EDT 2012 | cyber_wolf
Actually the correct way to fix this is to carefully remove the belt on the rear of the machine that connects the left and right rail lead screws together. Square the rails then carefully re-install the belt *without turning either of the lead screws
Electronics Forum | Tue Feb 15 03:56:18 EST 2022 | cbeneat
Is the wheel that drives the belt in alignment? I assume all the bearings are turning. We've had bearings in the past be on the edge of seizing in our end pulley's. Tightening too much could cause it to turn harder, causing the belt to jump off. Coul
Electronics Forum | Tue Feb 15 20:42:06 EST 2022 | jdengler
I think it is the belt. Looking at the video it appears to come off just after the splice goes around the pulley, so probably a bad splice. Jerry
Electronics Forum | Wed Dec 29 07:30:45 EST 2021 | vasu278
Hello, Iam looking for timing pulley for out conveyor and squeezes for MPM accuflex
Electronics Forum | Mon Apr 15 20:03:59 EDT 2002 | Jones
They work great as long as your conveyor speed has been calibrated and checked on some type of PM schedule. On some oven types these sensors can warn you to possible problems with the conveyor speed. Say the oven is calculating that the board is movi
Electronics Forum | Sat Aug 24 08:01:28 EDT 2002 | kumarraju
Hi CS Tan, Most customers expecially tend to neglet maintenance of the machine. As in the case of Dek 288 most of the end users have the impression that the 288 is one of the worst machines by Dek. But till today although Dek has discountinued manufa