Electronics Forum | Mon Mar 11 07:05:06 EDT 2024 | klauss
while conveyor goes down to relaese pcb, some big compoments are swinging left or right due to high down speed of the conveyor. is there any way to decrease the speed?
Electronics Forum | Mon Nov 01 09:56:57 EDT 2021 | richardcargill
Update - Solved On talking with BTU they mentioned that if the conveyor is always running full speed then cleaning out the motor brush area with compressed air will cure it. I'm guessing that the carbon dust had encroached onto the encoder. A good b
Electronics Forum | Mon Oct 25 13:06:54 EDT 2021 | richardcargill
Can anyone shed any light on the Speed configuration setting on a BTU VIP70? We're using Winconv2.4a if that matters. There are only 3 editable fields in the configurator, Pulses per unit - Power - Distance. I'm struggling to find out what constitu
Electronics Forum | Fri Oct 29 07:19:22 EDT 2021 | richardcargill
Thanks for the file, it explains pretty much everything we needed. It would seem we have more problems than just that now, I've got the conveyor physically running at about 18 i/m but the Actual speed display on the screen reckons it's several hund
Electronics Forum | Mon Jan 15 13:49:09 EST 2007 | leemeyer
Hello all, I am having some trouble with the conveyor speed on an Omniflow 7 reflow oven. Recent profiling showed that the conveyor was running to slow so I calibrated the speed using the instructions in the manual. After calibration there was no ch
Electronics Forum | Wed Jan 17 21:19:08 EST 2007 | Jnet
I believe the drive of the conveyor whether rail or belt is the same so the sprocket choice in the software would effect belt or rail conveyor speed. I would make sure the number of teeth match the sprocket selection in the software.
Electronics Forum | Tue Mar 28 04:49:39 EST 2006 | AR
All's well that end's well: I replaced the Dart speed controller card and the problem disappeared completely. But no harm in giving the chains and the rails a thorough scrub although they weren't the culprit in this case. Many thanks to everyone for
Electronics Forum | Mon Jan 15 19:21:08 EST 2007 | SWAG
Not sure if this has any bearing on the problem but did you check to see that T2 and T3 are jumped on the speed control board per the first note in the prodedure?
Electronics Forum | Tue Mar 05 09:11:11 EST 2019 | slayervv
The conveyor on our Topaz runs for about a second then stops. Turning on conveyor manually does the same thing. While conveyor is turned on manually, disconnecting and reconnecting 208AC at connection board starts the conveyor for a second then it
Electronics Forum | Mon Mar 20 06:21:42 EST 2006 | AR
Have a problem with Omniflo 5 (-97 vintage) pin chain conveyor. Occasionally the conveyor stops for a second or two, then makes a slight jerk, then stops again, makes a jerk etc. Then suddenly the problem goes away only to return next day (we switch