Electronics Forum | Mon Dec 12 22:14:42 EST 2005 | davef
�a va Frank? Well, popularity depends on the beholder. Never heard of your "Specnor" machine. US and Eurolanders take different approaches to conveying boards. * US: Finger conveyors * Eurolanders: Pallet conveyors Suppliers of wave solder machin
Electronics Forum | Fri Nov 20 00:14:23 EST 2015 | ttheis
To clarify- what I have is: 1. Manual stencil print process 2. Dynapace conveyor into GSM 3. Dynapace conveyor out of GSM into oven So what I need is a way to tell the conveyor into the placement machine to "go" when a board is loaded onto it after
Electronics Forum | Fri May 02 16:23:06 EDT 2014 | jimmyboz
Bits 0-3, no, Bit 4, MFU2 with error parts conveyor for camera 12, Bit 5,MFU1 with error parts conveyor for camera 12. The other guy is also correct, where to discard a component is in the part data. Still checking, please reply quickly if you solve
Electronics Forum | Fri Jul 23 09:31:52 EDT 2004 | cyber_wolf
Make sure that your mesh conveyor drive chain is not jumping a sprocket tooth. This will cause the conveyor to "pop" and you will have skewed parts. I seriously doubt that it is your profile causing skew. It is more than likely something mechanical.
Electronics Forum | Wed Aug 23 14:09:14 EDT 2006 | Chunks
Wow, I didn't realise we sucked so bad... I never replied because I've never worked with a scanner/conveyor process for wave. I think I got confused searching the archives for Brit spelling humor!
Electronics Forum | Wed Aug 31 17:12:23 EDT 2016 | ttheis
Yeah, it's set to use SMEMA for down line. I have the conveyor conected to downline fmi on up500 (right side of machine,) but the Upline Ready light is activated on the up500 when the conveyor is ready and not the downline like I would expect to see.
Electronics Forum | Mon Oct 01 14:42:18 EDT 2001 | Doug Sanders
Dan, Fuji has the NP XL series that will allow 27 by 23 inche boards using a conveyor.
Electronics Forum | Thu Jan 23 20:55:19 EST 2003 | davef
While not familiar with the flux, I'd increase the conveyor angle in a New York Minute.
Electronics Forum | Thu Jun 23 18:21:36 EDT 2005 | cmiller
Does the board appear to be in the right possition on the conveyor when the camera comes to look at it?
Electronics Forum | Mon Sep 22 17:18:23 EDT 2008 | jlawson
Another is Specialty Coating Systems (SCS) Have Benchtop to full higher production inline units