Electronics Forum | Fri Feb 21 00:23:30 EST 2003 | Dreamsniper
Technology keeps changin' and you need to keep on upgradin'. Lucky are those who work in a company that acquires advance equipment and technology yearly or everytime they are available, they are called the trend setters. Training coupled with hands-o
Electronics Forum | Thu Feb 23 14:06:19 EST 2006 | pjc
Positive Displacement Pump technology is in fact used for the underfill process. Both Camalot Systems and Asymtek both use them. Asymtek also has the Jetter and Camalot has the Multi-Piston Pump, specifically designed for underfill applications. The
Electronics Forum | Thu Jan 23 12:43:14 EST 2020 | pavel_murtishev
Hello, There is curious PCB technology used for one aluminum LED PCB. First of all there is no solder mask. PCB tracks look grainy and there is no fillet near components. Tracks near components are thicker. A kind of material has been applied to
Electronics Forum | Fri Dec 16 11:04:23 EST 2005 | chunks
Over all time will be dictated by your conveyor speed. Your conveyor speed will be dictated by your products time above liquidous. Time above liquidous is dictated by the manufacturers specification. Time and temp before reflow will have to be ach
Electronics Forum | Wed Jan 23 15:33:34 EST 2008 | vance66
I am looking to scan small 2D barcodes in-line while the circuit board is on a conveyor. Currently an operator is picking board up off the conveyor to scan them. We want something that is fixed and does not need to much manual alignment from changeo
Electronics Forum | Mon Jul 20 23:06:49 EDT 2009 | mika
10 or even up from a UIC conveyor of the old model - probably SMPI is the connector from UIC fully loaded, then full SMPI, but not all of them are used. Just Good board, bad Board, send, receive acknowledge. It is possible to convert this into SMEMA.
Electronics Forum | Thu Apr 23 12:22:35 EDT 2015 | ercdave1
Thank you for looking at my post. my problem is this. I have a Conceptronic Mark 111 Reflow oven that randomly turns off zone 4 and stops the conveyor belt. turning the heater and the conveyor off on the software and restarting them gets things ba
Electronics Forum | Mon Aug 27 15:50:05 EDT 2001 | seand
Hello Everyone, The MPM UP 3000 may be a good bet for your Screenprinting application and I am aware that there are a few in inventory at Speedline Technologies (MPM) that you should be able to get with a warranty for a good price. I know wide vers
Electronics Forum | Fri Mar 17 16:39:33 EST 2000 | Larry
We have just installed an omega wave to our W/S machine and are tring to W/S some of our bottom side surface mount components. I am still getting skips on some sot 23's. The component lay out meets all IPC 782 guidelines. I have verified these setti
Electronics Forum | Wed Aug 23 14:59:32 EDT 2006 | bill
I�ve been lurking on the forum for a while so I will take a stab at this, mainly because there is no answer I take it that you have a variety of boards being produced at the same time and are in fixtures so the conveyors don�t need to be adjusted, a
.gif)
winsouce.jpg)