Electronics Forum | Thu Sep 29 19:45:23 EDT 2011 | edwaterfall01
The conveyor is programmed to turn off the belts and go into an error condition after 30 seconds if the board has not passed the output sensor on the conveyor. The intent is to indicate a board jam and prevent damage to the board or belts. On convey
Electronics Forum | Wed Nov 23 19:24:04 EST 2022 | proceng1
Is there an IO screen so you can see what sensors are tripped?
Electronics Forum | Mon Nov 21 15:52:21 EST 2022 | crystalw4280
The internal conveyor stopped working...won't take board in. Says there is a board inside machine...is it a sensor problem? Any suggestions? Nothing led up to this. Just started machine up after weekend, and it will not take the board in.
Electronics Forum | Wed Nov 23 19:08:20 EST 2022 | leeg
You should be able to check the sensor, most had have the red light to indicate that a PCB is being detected. Depending on the version of software it should tell you within the manual control option too
Electronics Forum | Thu Nov 24 01:21:42 EST 2022 | crystalw4280
The bottom piece of the sensor broke, and it threw it off, fixed now. Wasn't sure, it must have come loose enough to throw it off, but not enough to trigger an error that it wasn't working...because it was still in the casing
Electronics Forum | Mon Mar 01 14:48:23 EST 2010 | g2garyg2
SUNSDA conveyors from China seem to have a special Chinese PLC control board that also requires a Chinese laptop and special chinese only software to make PLC changes. Just wondering if anyone knows how to access the PLC to make timer changes vs. fl
Electronics Forum | Fri Nov 20 00:14:23 EST 2015 | ttheis
To clarify- what I have is: 1. Manual stencil print process 2. Dynapace conveyor into GSM 3. Dynapace conveyor out of GSM into oven So what I need is a way to tell the conveyor into the placement machine to "go" when a board is loaded onto it after
Electronics Forum | Fri Apr 06 08:45:30 EDT 2018 | rob
Hi Reckless, No, I don't think it's a $1K job, just for the hours needed. You still need to learn the absolute basics, such as navigating the menus, creating a program, nozzle changing, identifying parts with the laser and camera, Pick timers, z hei
Electronics Forum | Sat Mar 25 06:07:41 EDT 2023 | smtusa
The part that sticks out in the rear for conveyors can that be removed if running in manual pcb loading only?
Electronics Forum | Fri Jul 23 12:52:35 EDT 2004 | Micheal
I would take a good look at Juki's 2000-series machines. We have a few and they are very easy to learn. Setup is minimized with offline setup. Adjust conveyor width and you are ready to run. Juki has provided good support and the machines require
