Electronics Forum | Fri Jan 21 00:46:28 EST 2011 | padawanlinuxero
www.flickr.com/photos/94427924@N00/5372753378 hope this is better
Electronics Forum | Thu Jan 20 11:02:46 EST 2011 | dyoungquist
Armando Link does not work. Goes to a "page not found" error in flickr.
Electronics Forum | Sun Jan 23 17:26:48 EST 2011 | piter
Hi In my experience try to change component to another batch or anther manufacturer it is very often problem in reflow when components have strange finish
Electronics Forum | Wed Jan 12 10:41:20 EST 2011 | padawanlinuxero
Hello guys ! I have a problem, I am finding some blow holes in the solder join in a resistors pad, can this be because of high humidity in the board? does baking the boards fix the problem? thanks
Electronics Forum | Thu Jan 20 08:22:14 EST 2011 | padawanlinuxero
http://www.flickr.com/photos/94427924@N00/5372753378/sizes/m/in/photostream/
Electronics Forum | Fri Jan 21 11:00:56 EST 2011 | xps
Hi, in my experience, the humidity is trapped in the solder paste. Otherwise you can also try to : adjust preheat profile, and /or increase paste viscosity, and /or increase paste metal content (they are the most common causes).
Electronics Forum | Wed Jan 12 20:18:14 EST 2011 | Jacki
How many % were affected? If a few,it can be caused bcoz of PCB coating. We had encountered it and PCB house replaced for faulty boards. Since then, we do test first if we hve to solder PCBs from this PCB house.
Electronics Forum | Fri Jan 21 13:27:38 EST 2011 | mosborne1
Try baking your boards first to remove the moisture. Moisture and boards that have not been drilled properly will cause pin hole or blow holes in PTH. Also take a look the surface of the pads before printing. You maybe contaminating the surfaces of t
Electronics Forum | Thu Jan 13 17:46:04 EST 2011 | davef
We've never seen the defect that you describe, but in wave soldering-land blowholes usually are caused by moisture in the board that out-gasses through the too thin plating of through holes. * Bandaid fix: bake the boards * Long-term fix: Obtain boar
Electronics Forum | Mon Jan 24 06:19:04 EST 2011 | fönsi
Hello! I've had the same problem about one Jear ago. We had exessive building of voids in the solder joints. I recomment to take a pincer to break off some of the components. If the solder joint is good, the copper pad will stay at the solder joint
