Electronics Forum | Thu Aug 10 15:06:03 EDT 2023 | thecolonel97
We tried choking down the water flow to the coolers yesterday just below above the point of where we wouldn't detect flow in the system. This raised the temperature in both coolers for this test. This morning when cleaning the buildup, this had mad
Electronics Forum | Tue Nov 30 14:29:52 EST 1999 | Jay Claybrook
Looking for information on portable chillers or coolers used with the water type recirculation heat exchanger cooling modules on the TRS21 BTU double furnace ovens. For use where you don't have a chilled water supply in the facility. Any info would
Electronics Forum | Fri Aug 10 10:37:49 EDT 2012 | cyber_wolf
Has anyone out there ever successfully rebuilt a CP642 transmission cooler oil pump ? Any tips or tricks would be appreciated. Thanks
Electronics Forum | Tue Jun 26 08:42:34 EDT 2007 | grantp
Hi, It's much better to add the cooler after the tank, as the tank will condense a lot of the water before it even hits the cooler and goes out. It's a much better system to have the tank between the compressor and then the cooler. The air also get
Electronics Forum | Mon Jun 25 10:42:43 EDT 2007 | fredc
On our new shop we used iron pipe in the walls and attic and copper ever where else that can be easily accessed. I saw a pvc material at a trade show years ago that was rated for air lines. With their demo material they could fold it and drive nails
Electronics Forum | Tue Nov 30 16:47:16 EST 1999 | John Thorup
Hello Jay I don't know what your requirements are but McMaster-Carr has a selection in their catalog John Thorup
Electronics Forum | Mon Apr 19 15:19:34 EDT 2004 | wgaffubar
I have seen problems when printing below 18% with our paste. We use a swamp cooler to dump moisture back into the room. It usually get to about 28% and the printing issue disappear. arcandspark
Electronics Forum | Fri Dec 17 10:24:23 EST 2004 | rlackey
Hi Matt, What printer are you using? you may be able to get an envronmental unit for it to keep the paste cooler & at the right humidity for longer, thus extending it's effective window. Cheers, Rob.
Electronics Forum | Tue Jun 28 13:23:56 EDT 2005 | Bob Gilbert
Matt, Try a cooler profile by simply speeding up the conveyor by 10%. The difference may be the temperature the pads are reaching between the HASL boards and the Au boards. Are they the same thickness?
Electronics Forum | Fri Jan 27 14:13:08 EST 2006 | Chunks
JOTs works well. Has built in coolers. Also realigns your boards back to an edge belt conveyor. Very well designed.
