Electronics Forum | Tue Apr 08 08:01:35 EDT 2014 | cyber_wolf
So we had a ringblow pump blow up in our CP642. We replaced it and now we are getting hardware NG errors very intermittently.(2-4 times during and 8 hour shift) I see that the x-motor fan, cam motor fan,and oil cooler are all in this circuit. When i
Electronics Forum | Thu Dec 08 13:34:46 EST 2016 | spitkis2
We are currently experiencing with our SMD Solder > Reflow Equipment on Shooting-Up Zones (Zones > 3,4,5,7 & even Cooling Zone). PV exceeds about > 5-10 degrees with the SP. (ex: SP=140deg, actual > PV = 145deg & higher). Our equipment undergo a
Electronics Forum | Tue Jan 14 11:53:44 EST 2020 | avillaro2020
Hi Phil, thanks. I am successful using the same connector on small thinner boards 2-2.5kg) i cant make it work, tried all kinds of profiles with vapour phase but to no avail. Yes you read it right 4.3-6.3mm pcb thickness and 2-2.5Kg. And it is 44 lay
Electronics Forum | Tue Feb 04 09:21:48 EST 2020 | nhusa
There are two areas that are important when discussing cooling rate. One is the rate thru the liquidus, where a fast rate produces small grains in the metal and a slow rate results in larger grains. Although smaller grains are stronger normal SM
Electronics Forum | Thu Aug 23 20:51:15 EDT 2001 | davef
Every thing you need is in "links" here http://packaging.hp.com/. The only thing you need to do now is find it. Ah, so much information, so little time. Yeh yeh yeh, nice little ESD bags are good. Er, maybe sealed barrier bags might be better. E
Electronics Forum | Tue Aug 05 18:02:05 EDT 2003 | MikeF
Check the areas that are getting solder on the top side. If you have internal ground planes, and the ground plane pth's are not getting solder on top, and signal pth's are, it's a heat problem. If the ground planes are in the middle of the board yo
Electronics Forum | Thu Aug 21 21:05:39 EDT 2003 | Tom B
Dan, We, do alot of double reflow. Your right we typically see alot of the standards components, SOT's, SOIC's, Chip stuff. The largest we do with out adding epoxy is some 32pin PLCC's. We have several assemblies were were doing PLCC44's, Sockets
Electronics Forum | Wed May 19 07:38:42 EDT 2004 | Bob L.
I'm trying to help one of our remote sites solve a problem with a warped PBGA. The corners are lifted, creating columnar joints and the central balls are sometimes shorting. I've verified that it's not popcorning and I've got samples going to the l
Electronics Forum | Wed Apr 26 12:38:33 EDT 2006 | TMC
I would suggest you do the following: get a sample / scrap board that you will be reflowing, attach thermocouples at various locations on the board, send the board to APS or whomever. Ask them to run a profile based on your solder pastes manufactur
Electronics Forum | Thu Mar 29 14:43:22 EDT 2007 | jmelson
For a microscope, you want one with the greatest working distance and depth of field you can get. You don't want a lot of magnification, so something like 0.7 - 20 X is good. If you are buying new, have salesmen bring them by and actually try them
