Electronics Forum | Thu Feb 12 22:21:08 EST 2015 | shahrat
So what problems you are facing with Mirtec? Can u check coplanarity, less solder, polarity, dry solder,Pads not properly got the heat for 1005 package. Can u also check 0105 components that is surrounded by some tall components? what about false cal
Electronics Forum | Tue Mar 03 16:14:37 EST 2015 | lokit
Hello, No experience with Mirtec, they are more populair in the States and Asia it seems. For my company, not only the inspection depth and reducing false fails was important, but also good costumer support. Keep in mind that if you have problems w
Electronics Forum | Mon Feb 16 12:33:58 EST 2015 | ianatvadatech
Hey Syed, I've been running the MV-9 for just over a year. We shopped around very extensively (two APEX shows) before switching from yestech to mirtec and we bought two of the best systems they had to cover the four lines we run. Two systems are fa
Electronics Forum | Wed Dec 01 01:15:44 EST 1999 | Jeff Skeith
dave, you are right on. a blow torch isn't needed to light a fire. a small coplanar aluminum block works extremely well. my dept fixes thousands of fine pitch parts to to less than 4 mils from low lead to high lead every month. all we use is a sm
Electronics Forum | Tue Oct 26 13:18:07 EDT 1999 | Jerry Stafford
Anyone know or have experience with a
Electronics Forum | Wed Oct 27 07:45:02 EDT 1999 | Mario
Previous message should say "this is NOT an automatic operation" it is still done by an operator quite easily.
Electronics Forum | Thu Oct 28 10:37:33 EDT 1999 | Karl
You should check out this site www.isystems.com
Electronics Forum | Mon Feb 25 17:07:15 EST 2002 | peterson
We are using a Panasonic MPAV2 to place some QFP's. Can someone please help me with a problem we are having with coplanarity! The machine is "dropping" parts due to coplanarity issues. What settings should we be looking at in order to eliminate the
Electronics Forum | Mon Apr 09 11:39:32 EDT 2018 | emeto
The easiest way to do without special tools is to use level. Check machine co-planarity on the conveyor rails in both directions(you can do that with rails down or rails up or both). Then check co-planarity on the stencil. If the level shows the sam
Electronics Forum | Wed Mar 10 08:19:01 EST 2010 | aajmera
We have these standard pitch QFPs, for which we found some coplanarity error issues. The issues surfaced during BLT. We do not have any instrument to measure the coplanarity error before the component is loaded on the placement machines. Is there any
