Electronics Forum | Thu Jun 22 16:59:18 EDT 2000 | Lee
I'll be real brief, because of time, but feel free to contact me later (lgoldberg@chipcenter.com). There is big conceren (somewhat well-founded but a bit overblown) about lead form electronics products leaching into the environment when they are land
Electronics Forum | Thu Aug 06 19:20:09 EDT 2009 | boloxis
easy, just dip the ICs on a very weak solution of Nitric Acid, by very weak I mean like drops of Fuming Nitric acid in a half full DI water beaker. Place the beaker on a Ultrasonic bath and dip/shake the ICs in the solution in 5~ 10 seconds only. You
Electronics Forum | Thu Nov 17 20:23:55 EST 2005 | davef
We're with your customer. We believe inner layer separation is not linked to a heating excursion. What you are seeing is separation between the hole wall and the copper plating in the barrel of the hole on an unstressed PTH. Although, it's possibl
Electronics Forum | Thu May 11 11:25:56 EDT 2017 | davef
Key to Rosin Fluxes [from SUPERIOR FLUX & MFG. CO.] Type R (Rosin): Non-activated rosin flux for soldering copper. Residues are non-corrosive and non-conductive. Type RMA (Rosin Mildly Activated): Mildly activated rosin flux that contains no chlori
Electronics Forum | Thu Jun 29 12:07:09 EDT 2017 | georgetruitt
HOW THICK IS THE BOARD? IS THERE A LOT OF COPPER IN THE BOARD? DOES YOUR CUSTOMERS PROVIDE HEAT RELIEF IN THE BOARDS BARREL DESIGN THERE NEEDS TO BE PLENTY OF ROOM FOR LEADFREE SOLDER TO FLOW, DID YOU CHECK YOUR PIN(LEAD)TO HOLE (BARREL) RATIO? N
Electronics Forum | Sun Aug 15 05:45:15 EDT 1999 | Brian
Boca, Dave Sorry, but I cannot let this go. I'll go along with you that, at the time that the Montreal Protocol was initially signed (September 1987), there was no scientific proof that CFCs etc. were causing ozone depletion. There was, however, ve
Electronics Forum | Thu Jul 15 19:05:58 EDT 1999 | Earl Moon
| | | We have been encountering diminishing ball shear readings these past few weeks, despite the fact that we did not change any ball shear tester parameter. Our reflow parameters are also within spec limits. ( 210-220 deg C max temp. and 40-60 sec
Electronics Forum | Fri Dec 10 08:42:37 EST 2004 | mattkehoe
We had some bad experiences trying to work with soldermask defined BGA pads. If the opening in the soldermask is right to the edge of the copper/pad without a space it can leave reside on the pad and nothing will stick to it. See http://www.sipad.com
Electronics Forum | Tue Nov 21 19:23:15 EST 2006 | greg york
Had exactly the same problem the other week. Baked some boards did improve slightly but not convincingly. Washed bare PCb and found excessive HASL fluids left on board from improper rinsing and problem disapeared. Baking HASL fluid out is impossible
Electronics Forum | Tue Dec 23 11:55:37 EST 2003 | Marc Simmel
Details, details: 1) The metal shell is part of the component body. The base metal is austenitic stainless steel (304) that has been plated with 90/10 tin-lead over nickel (semi-bright). 2) The entire part (leads and shell) is elevated by the mass o
