Electronics Forum | Fri Nov 27 00:36:02 EST 2015 | slouis2014
I just encountered a BGA design were in, underneath the BGA is a silkscreen that covered the entire bottom of the component except for the copper pads. Can you give any information and advice for this type of design.
Electronics Forum | Fri Dec 04 05:47:57 EST 2015 | rushpcbuk
In PCB design, a BGA (Ball Grid Array) package typically determines the number of layers that a Printed Circuit Board should have. However, the 4-layer board with a BGA package is commonly used than a 2-layer than an 8-layer PCB. On the other hand, t
Electronics Forum | Wed Nov 10 02:20:07 EST 1999 | Marc
The padsfor large heat sinks are being designed on our boards with large copper ground planes surrounding them by our engineers. I am having great difficulty keeping the reflow temperature below 230 degrees in order for the temperature of the copper
Electronics Forum | Thu Nov 25 20:28:43 EST 1999 | cklau
hello, One way to prevent copper land delamination is to applied Anchoring spurs also referred to as "tie-down tabs" or "rabbit ears".These are a metal projection around a land.This features is fully captured by the cover lay (cover coat) that is n
Electronics Forum | Mon Jun 02 16:33:35 EDT 2008 | operator
Is there some good resources (.pdfs, websites, articles) that someone can point me to regarding design for bga footprints? I need to brush up on thermal relief design for bga footprints. I got a customer whose bga lands are masking defined on top of
Electronics Forum | Fri Dec 20 09:01:27 EST 2002 | russ
Greetings, Does anybody out there have any experience with 0306 capacitors (not 0603). I am trying to find a pad design for this component. I have searched the archives to no avail. The component is .06 long by .03 wide with .007" solder terminat
Electronics Forum | Wed Jan 27 04:01:46 EST 2016 | slouis2014
Thanks alot for the info
Electronics Forum | Fri Dec 04 23:15:45 EST 2015 | mac5
You say that there is no green solder mask around the lands of the BGA only silk screen. If that is the case I would be concerned about the solderabilty of the component if the silk screen gets onto the pads. The application of solder mask is much mo
Electronics Forum | Fri Dec 20 12:12:12 EST 2002 | russ
Thanks Dave, I was looking in the Murata data base and couldn't even find the part (Even though they are the ones making it)let alone the pad dims. This part looks like it could be fun anyway. Russ
Electronics Forum | Mon Nov 30 08:39:05 EST 2015 | spoiltforchoice
http://blog.screamingcircuits.com/2010/09/smd-vs-nsmd.html such as this? Which handily also tells you what you might want to google.
