Electronics Forum: corner dog errors (Page 1 of 5)

unknown nozzle st 17

Electronics Forum | Wed Nov 20 10:21:09 EST 2013 | cyber_wolf

Station 17 and 19 errors are almost always caused by dirty clutches or bad sensor dogs. My guess would be bad sensor dogs in this case if it only does it on certain jobs. The reason it happens on those jobs is because there are nozzles being indexed

Warming up solder paste at start of days production

Electronics Forum | Mon Jul 26 16:46:40 EDT 2004 | Frank

Can you use one of those hot-dog rollers (cookers?) you see in the corner convenient stores to keep the paste tubes moving to eliminate the separation? Ya know, the cookers with the week old hot dogs on it that are all shrivelled up?

IP-3 Nozzle Change Error (Chuck Confirm. Sensor ON)

Electronics Forum | Thu Jan 07 20:15:29 EST 2021 | greezmky

I fond two dogs in a cabinet and they appeared to be new. I replaced the dog with one of them and it seems to be working great.

CP6 Nozzle sticking

Electronics Forum | Mon Mar 07 18:41:13 EST 2005 | jimmyb

--IE, Funny.--- I "remember" kinda, from the early CP6 years, things about the springs. The early Fuji springs had sharp ends, and if you spun the nozzle, prior to final attachment, the opposite way it could stick, and if it was spun the right way,

Pick and Place Machine Validation

Electronics Forum | Thu Mar 10 12:19:17 EST 2005 | rlackey

Borrow a large hungry dog (or wolf if local wildlife permits) & chain it up in the corner of the office when the salesman comes in. Then look over at it repeatedly whilst talking about your requirements. Feel free to leave him alone for a while...

IP-3 Nozzle Change Error (Chuck Confirm. Sensor ON)

Electronics Forum | Wed Jan 06 11:05:13 EST 2021 | greezmky

Thank you rtmitchell, being unfamiliar with the system, I missed that the end is slightly nicked. I pulled a dog out of a machine that has been cannibalized, I verified that it was straight and not nicked, and installed it in our production line mach

how to prenvent flux risidue in the blind vias.

Electronics Forum | Mon Feb 19 22:56:20 EST 2007 | davef

Russ We agree with your comments on plugging from one side only. But... We believe that it IS possible to trap process chemicals [technically, not flux] in a blind [or any other] via. This can be done by plating the via closed, rather than pluggi

IP-3 Nozzle Change Error (Chuck Confirm. Sensor ON) SOLVED

Electronics Forum | Tue Jan 05 17:12:20 EST 2021 | greezmky

Before our holiday shutdown an experienced party came in and showed me the PAM process on the IP-3. We made some adjustments, and all was well. Yesterday I found that we may have accidentally mixed up some nozzles, so I verified where each should go

What causes Bga corners to lift during reflow

Electronics Forum | Sat Sep 27 09:32:36 EDT 2003 | mantis

All, I was wondering what causes the corners of a bga to lift during reflow process.Now just to clarify i have been running this one particular product for 4 years and i have the process and reflow profile down to a tee.But recently i have witnessed

Machine down

Electronics Forum | Mon Sep 29 13:36:01 EDT 2014 | dustin

I came into work this morning to an error on one of my printers. After powering on machine, the error MACHINE DOWN popped up in the top left corner of the screen. I have the giant manual and could not locate a solution for this error. I have checked

  1 2 3 4 5 Next

corner dog errors searches for Companies, Equipment, Machines, Suppliers & Information