Electronics Forum | Thu Aug 17 13:55:45 EDT 2023 | markhoch
I think we need more information. Is it moving at all? Does it move to a reference position and then stop before returning to the home position? Have you verified that all sensors are working correctly? Does the machine use stepper motors, motors & e
Electronics Forum | Wed Nov 20 10:02:54 EST 2013 | dekhead
R)... This will be primarily seen in the "Y" direction with minimal effect in "X". It is possible that one of the chase rails is not locked (spring-loaded lock on rear), and changing position during screen load. http://www.dekhead.com
Electronics Forum | Tue Nov 19 12:36:01 EST 2013 | youngbuck
DEK Infinity-Does anyone have any information on why the automatic screen changer would load the same screen in a different position everytime you load and unload? We constantly have to do a search step for the fiducial and most of the time it will e
Electronics Forum | Fri Nov 17 09:29:27 EST 2000 | CAL
Some more information is needed. Is there a machine error indicating a mispick? Or a vision error Component missing? I am not as familiar with UIC machines as I am with Siemens but here is my $.02 anyway. Try shimming the feeder under the pick up pos
Electronics Forum | Fri Nov 17 00:27:30 EST 2000 | DL
Kris, I gather from your description that the component can not be picked consistently. Meaning that the machine can place the component. How does the component place? Is the placement text book? Take a good look to see if the component isn't being
Electronics Forum | Thu May 05 01:50:44 EDT 2016 | darby
Dear Forumites, It's been a while, but I have a question. I was recently asked to provide a scenario on capacity if we retired two older lines and replaced with a new line. My capacity figures were based on real time production over a period of six
Electronics Forum | Mon Feb 14 05:58:06 EST 2011 | vinitverma
Gabe, You now need to teach the Datum position for the front feederbar and for the rear feederbar too. If I'm not mistaken the datum position for the front feederbar is position no. 21. Just put a feeder on position no. 21 and use the camera to find
Electronics Forum | Fri Jan 04 14:42:20 EST 2013 | mcox
Philips Gem Topaz - Does anyone have a decoder ring for calculating the correct place angle for components. I am looking for a fool proof way to program the correct angles depending on how the parts are supplied to the machine. Thanks Mike
Electronics Forum | Wed Aug 20 09:11:33 EDT 2008 | jsims
We ran 3 750's, a 2060, and a 2080 for about 10 years. If you'd like to talk about it offline, give me an e-mail. jsims@schrader.co.uk. We had a positive experience. Good luck. John S.
Electronics Forum | Tue Feb 15 00:27:39 EST 2011 | jeffr
First clean and de-bur the hole in the nozzle, then try it again. If the Head does not pick up at the feeder, then moves to the dump position...it means that the Vacuum Sensor Board has detected that the nozzle vacuum is above the LOW threshold setti
