Electronics Forum | Tue May 05 07:28:21 EDT 2015 | sarason
That is very dependent on what components are needed for your boards. In general if you are running high volumes you talk directly to the manufacturers. If they think your 10,000 boards ain't worth getting out of bed for, they will refer you to thei
Electronics Forum | Mon Aug 10 15:15:17 EDT 2009 | indity
I have very little knowledge of pick and place machines or assembly, and was hoping someone could give me some advice of where to start looking. I do learn quickly so I am not afraid of challenges or learning through mistakes. I need to produce abou
Electronics Forum | Wed Dec 29 15:42:34 EST 1999 | Mike Naddra
Justin, I would be currious as to your customers application, and if the temperature delta and rate are great enough to cause solder joint failures as a function of mismatched Tce then you may want to consider that even if you are able to identify
Electronics Forum | Thu Dec 30 21:22:12 EST 1999 | Jim
Mike, Thanks for the reply. It's not really a matter of slope. It is the long term thermomechanical fatigue that the solder joint undergoes as a result of repeated severe temperature swings, while the product is in use. Non-leaded parts are suscep
Electronics Forum | Fri Aug 04 15:46:08 EDT 2006 | Chunks
Two reasons company B is asking $40 instead of $15-$20; 1. The set-up of their placement equipment takes time, thus the extra labor. Parts may be hard to get or what they norm keep in stock, plus storage of parts. 2. They know they can get awa
Electronics Forum | Tue Aug 18 22:22:43 EDT 2009 | comatose
Assuming you want to run 8 hours a day and 5 days a week, you need a sustained throughput of 2.5k components per hour. With fine pitch, futzing around, setup, etc you should really look for machines rated in the 4k to 5k per hour range. That's not sc
Electronics Forum | Wed Sep 30 16:57:57 EDT 1998 | Cunli Jia @ SMTnet
Please check out MV Technologies at www.mvt.ie. They are one of our generous sponsors. Good luck. Cunli
Electronics Forum | Wed Sep 30 20:44:50 EDT 1998 | Wayne Bracy
You can also check out I Systems. Make vison inspection and measurement equipment Wayne
Electronics Forum | Wed Sep 30 15:27:34 EDT 1998 | jvo
I've been looking for a vision system which can check our fully mounted boards containing a mix of smt and thru hole. The concepts on all the machines are virtually the same, they got about 12-16 cameras, some pcb fixing and the rest is software.
Electronics Forum | Wed Sep 30 16:36:59 EDT 1998 | Dana R Simon
I've been looking for a vision system which can check our fully mounted boards containing a mix of smt and thru hole. | | The concepts on all the machines are virtually the same, they got about 12-16 cameras, some pcb fixing and the rest is soft
.gif)