Electronics Forum | Mon Oct 04 10:26:59 EDT 1999 | Morris
I am working on trying to define a cost per placement measure in our SMT assembly operations. Does anyone know where I might find a published industry average that we may compare to? I�ve heard it stated that an industry average is less than $0.01
Electronics Forum | Tue Oct 05 01:22:46 EDT 1999 | Karlin
| I am working on trying to define a cost per placement measure in our SMT assembly operations. | | Does anyone know where I might find a published industry average that we may compare to? | | I�ve heard it stated that an industry average is less t
Electronics Forum | Tue Oct 05 06:28:32 EDT 1999 | Wayne S.
|hello morris type in quoting smt in archives and you will get some good insight. i had the same question at one time. wayne I am working on trying to define a cost per placement measure in our SMT assembly operations. | | Does anyone know where
Electronics Forum | Wed Mar 29 18:45:49 EST 2000 | Dreamsniper
Anyone wants to share his idea or method of calculating Cost per placement in both high and low volume manufacturing environment? Thanks,
Electronics Forum | Thu Mar 30 11:08:56 EST 2000 | Michael Parker
Ceeris International has a Cost of Conversion Benchmarking study that should give you all of the facts you seek. www.ceeris.com
Electronics Forum | Thu Feb 16 05:59:38 EST 2006 | jobbie
Hi everyone, New to the forum and have a question. How many cph are others getting? We are small sub-contract firm and are running Mydata my12 with hydra, but not agilis feeders. We tend to do small batches (upto 100 circuits), high mix from 0402 to
Electronics Forum | Wed Oct 13 03:38:21 EDT 1999 | Paul Gerits
Hi Morris, I work as a technical consultant, application specialist for Philips EMT (SMT machine suplier). For cost per placement complex calculation can be made. To make a easy one just to hav an idea you can use following. Information needed: Pr
Electronics Forum | Wed Oct 13 12:12:04 EDT 1999 | Bill Haynes
Hello Morris, I hope that my superiors don't see your message or they might have me go through all of that to calculate my cost per part mounted. One of the things that has helped me out considerably is an Accounting report that gives me all
Electronics Forum | Thu Apr 28 02:03:10 EDT 2005 | Yngwie
Just to check and see if I'm using the right formula in my "cost per component placement" calculation is correct or not. Any input would be much appreciated. Total cost of the machine : A Depreciates over 5 years Actual/best UPH obtained 11000 cph
Electronics Forum | Thu Feb 16 06:37:07 EST 2006 | Mity-C
Good Morning jobbie, We have several Mydata lines. We are building low volume high mix as well. Our CPH had been identified as approximately 6000-8000 CPH depending on the application of course. We do have a separate setup area however that stages a
winsouce.jpg)
