Electronics Forum | Tue May 14 12:28:30 EDT 2002 | yquem
Does anyone have a template or a method of approximating remaining part count on a started reel? We are not ready to purchase an electronic parts counter at this point
Electronics Forum | Tue May 14 18:07:27 EDT 2002 | soupatech
My method is not good if accuracy is an issue. Most of our reels come with a guage on the back. It is not a perfect count but with a good eye you can get within a couple hundred on reels of 5k. On the reels shipped with no guage I usually just hold a
Electronics Forum | Tue May 14 20:45:45 EDT 2002 | davef
Ashok Dhawan, an old friend of SMTnet, says: Formula for counting components on SMT tape & reels [spiral belt]: Length = Number of turns * 1/2 * 22/7 * ( dia outer + dia inner), where ... Number of turns = ( dia outer - dia inner) / thickness of
Electronics Forum | Mon Aug 06 14:08:56 EDT 2012 | dyoungquist
We run a MY12 and our largest layout has 9700 components of which about 8500 (88%) are placed by the Hydra head. Average run time for our layout is 75 minutes. Based on that and depending on what percentage of your components are Hydra mountable, y
Electronics Forum | Thu May 12 10:02:21 EDT 2011 | scotceltic
Our company has it's yearly inventory coming up. (Joy). I was wondering if anyone has come across a component counter that can handle radial components in AMMO pack. I have seen plenty out there that can handle counting of radial components in Reel
Electronics Forum | Fri Mar 31 16:57:51 EST 2006 | stepheniii
97% to 99%? I've heard of one company that managed that but only after a big six sigma project. And they had minimal stock anyways. I think if everyone picked 100 components to cycle count, that the average accuracy would be around 80% . That is
Electronics Forum | Thu Mar 18 19:53:29 EDT 2021 | lhd_qa
Hello everyone. I am new to the forum so I am sorry if this has been asked before. Does anyone have any suggestions for counting partial reels and cut tape? We are a distributor and for our ecommerce PDC we keep having quantity issues. Currently, we
Electronics Forum | Fri Mar 19 12:51:11 EDT 2021 | lhd_qa
Thanks for the insight, we will have to look more in to them.
Electronics Forum | Tue Mar 30 12:19:11 EDT 2021 | chicagoindustrial
+1 for x-ray. It's the only way to go.
Electronics Forum | Thu Mar 18 23:09:27 EDT 2021 | cbeneat
We use X-Ray for partials. It's at our other plant, but as far as I know they have no issues with count, quick too.
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
