Electronics Forum | Fri May 20 09:13:58 EDT 2011 | ck_the_flip
We have issues with the Philipps Luxeon Rebel LED where the part sticks to the cover tape during advancement. This causes the part to get flopped around in the pocket or the component gets dropped and damaged when the feeder advances. Has anyone ex
Electronics Forum | Thu Sep 20 09:12:28 EDT 2001 | jschake
If you were successful in running the machine in dry cycle mode, then I would expect with new squeegees that the prints would be acceptable. To give you more tangible data on what you may expect from the actual print results, maybe you could run the
Electronics Forum | Tue Sep 25 05:58:16 EDT 2012 | bobpan
I believe the Led's should flash 3 times when the card is booting up/ powering up normally. There was no board troubleshooting back in the day and we just replaced the card. Make sure the metal cover is grounded to the machine.....this sometimes caus
Electronics Forum | Mon Sep 20 13:05:05 EDT 2010 | dman97
Hi, Yes I tried to do that. When I stick a key inside the slot, I still get a system suspended error. Although I can press the system switch and I can hear the locks engage, but nothing happens. the machine still thinks the covers are opened and
Electronics Forum | Wed Jul 18 09:22:12 EDT 2007 | ed_faranda
You're on the right track. 99% of the time, it is caused by a feeder not seating correctly. Check and ensure that all your tape covers are down and LOCKED (very important). Which type of feeders are you using Q or K? One thing I have found with K
Electronics Forum | Wed Oct 26 18:25:13 EDT 2005 | darby
The encoder on the Y axis motor is almost certainly kaput. Debris from the wear of the motor brushes or whatever else can find its way onto the encoder and give an ever increasing false pulse. The axis will start OK but progressively go out of whack
Electronics Forum | Tue May 30 11:51:43 EDT 2000 | JAX
Sal, I have seen this problem placing SMT connectors which exceed 60mm in length. Although I did not use siemens equipment at the time I am not sure if they will place enought force to seat the entire connector flush to the board. They have a maximun
Electronics Forum | Wed Mar 24 23:04:00 EST 1999 | Al O Owzitgon
| We are dealing with down time accredited to the Pumps getting clogged with dried glue. We have decided to purge all spindles at 6 hour intervals. We are looking at making this process automated. Has anybody tried this and if so, is there a way to s
Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
Electronics Forum | Tue Nov 13 00:05:11 EST 2012 | eadthem
Typical problems with our heller 1707 EXL would be blower issues. We have almost replaced every blower on the top sense purchase. Fortunately Heller is very good about honoring there warranty on the blowers which is quite long, Might be lifetime not
winsouce.jpg)
