Electronics Forum | Sun Feb 09 18:20:24 EST 2020 | richardcargill
Does this only happen with certain feeders or certain components? We have a few regularly used components that experience the same problem ( Philips SMT machinery ) where the cover tape is just too sticky. Experience taught us which components will c
Electronics Forum | Fri Jun 16 15:50:08 EDT 2006 | Bert van den Berg
PSA - Pressure Sensitive Adhesive? I don't know which type of tape the affected reels of parts use but it is not sticky. Thanks everyone for the comments and suggestions. There were no missing teeth on the plastic take-up reels. I have cleaned an
Electronics Forum | Fri Jun 16 10:12:16 EDT 2006 | flipit
It it PSA tape or heat seal? Every machine I have ever used has trouble with PSA cover tape. I wish they would ban in in ROHS. 3M tells me it is the future and it will replace heat seal tape.
Electronics Forum | Thu Jun 15 03:31:26 EDT 2006 | Bert van den Berg
The cover tape on 0805, 1206 and IC reels occasionally does not pull back clear of the tape and our Fuji IP-1 stops. Although some feeders appear to be more vulnerable to this than others, is this a feeder problem or is this a material problem with
Electronics Forum | Thu Jun 15 08:44:18 EDT 2006 | jdengler
Bert, The original IP feeders do a poor job of peeling the cover tape. Things to check: -All teeth present on the take-up reel -Take-up reel has even drag as it rotates (reel out of round or dirty) -Take-up reel drag is not too high (locations and
Electronics Forum | Fri Feb 07 20:38:16 EST 2020 | orbitcoms
I am running a Sasmsung CP40-LV machine (which itself works fine). However, the thing holding up production is that I am often experiencing tape cover not being pulled back by the feeders. What part of the feeder is most likely to cause this? I have
Electronics Forum | Thu Jun 15 04:02:30 EDT 2006 | Rob
Hi Bert, It can be either - sometimes they put too much glue on the cover tape when it's sealed, and sometimes the feeder is not stong enough. We would get a lot of these on our fuji's after a shutdown, and they would diminish throughout the first
Electronics Forum | Wed Dec 13 12:08:57 EST 2000 | Stefan Witte
Apparently the adhesive tape peels off from the joint, which could have some reasons. 1. There should be an overlap of the cover tape, as Cal mentioned. The new cover tape laying over the old by approx. 2mm. I also peel the cover tape a bit off, whi
Electronics Forum | Wed Sep 21 10:40:18 EDT 2005 | PWH
Splicing for us has been a rough go as we haven't really found a tool that works well/fast. We have a few different machines = different feeders. They all react different to a splicing "style". The best so far is a crimp tool that crimps a brass s
Electronics Forum | Thu Feb 27 15:02:22 EST 2020 | babe7362000
Does anyone else have issues of certain cover tape that gets stuck in and around the feeders? I have been fighting these 2 tapes all day. I try to tape them to the pocket tape with a twist, but it only works so long. It happens Either because its s
