Electronics Forum | Fri Oct 08 22:14:38 EDT 1999 | Michael
Right now,we have some problem on SMT. Cause of the flux residue in the connector. Do somebody have the same symptom? By the way, can i find something to make the flux observe easy or take a photo with the flux.
Electronics Forum | Sat Oct 09 03:45:34 EDT 1999 | Brian
| Right now,we have some problem on SMT. Cause of the flux residue | in the connector. Do somebody have the same symptom? By the way, | can i find something to make the flux observe easy or take a photo with the flux. | | | Unfortunately, this pr
Electronics Forum | Wed Apr 20 11:37:17 EDT 2011 | markhoch
Hello, I'm looking for a supplier for an ESD Cover that I can use to cover my Feeder Tables that are not in use. (I'm thinking of something similar to an ESD Safe BBQ Grill Cover) Does anybody have these, or know where I might be able to find them?
Electronics Forum | Mon Jul 30 21:12:10 EDT 2012 | davef
We're seen components sticking to adhesive that was slobbered on the inside of cover tape.
Electronics Forum | Mon May 27 12:55:28 EDT 2002 | jgeissler
We are experiencing an increased amount of machine stoppage due to brittle 8mm cover tape. The issue does not appear to be feeder or part/manufacturer specific. Taking a foot of cover tape and pulling it from the ends results the cover tape snappin
Electronics Forum | Mon May 17 12:46:43 EDT 2010 | flipit
Big problem. Certain LED from certain manufacturer sticks to the tape and reel cover tape. Peel back the cover tape and every LED lifts out of the embossed pocket and sticks to the cover tape. I believe this is from static and not any sort of adhe
Electronics Forum | Wed Jul 26 12:22:28 EDT 2006 | cyber_wolf
The new universal guide replaces .7 - 1.8 mm tape covers. Fuji no longer makes the slitted type tape covers. How can the tape guide be mis-centered ?
Electronics Forum | Thu Jul 08 02:32:47 EDT 2010 | tivux
I soldered a wire in the tape press lever of th feeder, so as to create a small gap where the cover tape passes and the component doesn't: in this way the component is pushed down in the pocket as soon as it tries to follow the cover tape. regards,
Electronics Forum | Fri Mar 05 02:59:59 EST 2010 | grahamcooper22
Hi, Do you have a picture on one of these leads where the solder has covered the lead ? As this is a gull wing device I wouldn't expect solder to cover it. I expect to see a toe fillet / wetting around the sides of the lead and a heel fillet. If your
Electronics Forum | Wed Jun 30 11:38:05 EDT 1999 | Brian Conner
| We are wave soldering some fabs with a lot of unmasked trace area along the edges. The trace area is solid copper covered with tin / lead, no masking, no components along the edges, same on solder side and component side (goofy board design). Ins
