Electronics Forum | Wed Feb 26 10:54:18 EST 2014 | JB
Hello. Does anyone know how to add a different package to the Part Group on the Samsung CP45FV neo software? See picture. For example if we wanted a heading for Inductors, how do we add that? Thanks
Electronics Forum | Mon Dec 02 10:33:46 EST 2013 | sarivong0914
Hello all, We have a Samsung CP45FV Neo, and I'm having problems with the operating software. I have a PCB with 2 different rev's. Rev. A boards was programmed to run Vertical. Then Rev.B boards are horizontal but was programmed to run vertical.
Electronics Forum | Tue Oct 05 02:24:58 EDT 2004 | darby
What config are you replacing? ie 1 machine, 2 x 3machine lines, 1 x 2 machine line etc. What do you want to place with it? I can't comment on the Contact machines having never used one. On Samsungs I will say this. For your own benefit consider the
Electronics Forum | Tue Sep 01 06:15:09 EDT 2020 | bukas
do you get error when software loads or when you run program? once i had MPU stop because there was skipped array in my step file
Electronics Forum | Sat Jun 05 22:07:50 EDT 2021 | danniedarko
Hi, I live same error 3 years ago. I can fix this problem. but need remote access by (AnyDesk) software. and have 50USDT cost. send access information dannie.darko@outlook.com
Electronics Forum | Tue Sep 12 10:30:00 EDT 2017 | sambo
Hello, We currently have Samsung CP45FV and SM45IFC pick and place machines and are looking to invest in two new Fuji NXT III SMT lines. I'm looking for a conversion software that will convert our existing programs to Fuji format. Is there any softw
Electronics Forum | Mon Aug 04 10:19:55 EDT 2003 | Sat
Shortlisted a Samsung machine CP45FV for purchase for a medium speed application. Any feedback on your impressions of Samsung machines in general and also in terms of company, service, support, software etc. that you would like to share would be grea
Electronics Forum | Tue Oct 13 03:48:57 EDT 2009 | geb
Hi, The machine is a Samsung CP45FV-Neo. Is there a way to set the level of control operators have over a program? We'd like to have a program which can't be changed, except by a technician. I can't see any way of doing this with the machine software
Electronics Forum | Mon Aug 08 07:45:23 EDT 2011 | geb
Although I don't have the same model machine (ours is Samsung CP45FV) our Vib feeder had a "transportation" screw or strap (it was a few years ago) fitted that you need to remove before it vibrates properly. Ours has a on/ off switch on the feeder
Electronics Forum | Tue Sep 01 11:53:21 EDT 2020 | inspiredmorris20
bukas, Yes, as soon as the software loads it immediately throws a 0002 (front E-stop pressed) and will not come out of EMER mode until i stop, reset, ready, on the control panel. yesterday however it also threw a E100 I/O I/F board communication d
.gif)
.gif)
