Electronics Forum | Mon Jul 13 10:04:06 EDT 2009 | csm
Dear all, we have an Fuji CP6-4000 we get some weeks ago, but it shows an error "Hardward NG and show some actions (Inch the axis to cancel the overtravel. Then switch the power off and restart the machine). We did but display same error. I would li
Electronics Forum | Tue Jul 14 08:23:41 EDT 2009 | csm
Dear Jepoy I apreciatte your support, we will check and do all your recomendations an will let you know progress. Best Regards
Electronics Forum | Wed Jun 04 22:52:32 EDT 2003 | hwatali
Now we are in urgent to buy 1.FUJI CP6-4000 or CP6-5000 for 3 sets;2.FUJI CP643E for 2 sets;3.CP6 8��2 and CP6 8��4 paper feeder. If you can supply these to me,pls contact me asap.
Electronics Forum | Fri Jul 17 07:50:32 EDT 2009 | csm
Dear Jepoy We check the oilmatic system and I found a relay is not working, it will arrive until tomorrow. We still have 2 errors and 1 message, we are taking time because we don't have the Fuji CP6-4000 manuals or electric diagrams. we get this ma
Electronics Forum | Tue Jul 14 08:09:42 EDT 2009 | fujiphil
Check the following: 1. Cam Motor cooling fan. Check if the fan is running or not. Clean the cooling fan cover. 2. Check the oil coolant control box. Check all the contactors does not trip. 3. Check the circuit protector M1CP8, M1CP9 and M1CP10. One
Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg
Electronics Forum | Tue Nov 28 09:48:51 EST 2006 | cyber_wolf
Does anyone know why there would be magnets on the bottom of the locating plate on a CP6 feeder ? We seem to have some feeders with them and some without.
Electronics Forum | Tue Dec 05 06:40:09 EST 2006 | cyber_wolf
You are probably right about the oven fumes, but there are indeed magnets in the bottoms of some of the feeders.
Electronics Forum | Wed Dec 06 13:18:15 EST 2006 | jgarver1
Motorola had there own Verification system, which required magnets to be installed in the bottom of each feeder.
Electronics Forum | Thu Nov 30 06:53:31 EST 2006 | Rob
For the criminally insane to help them locate the feeders? Or to help hold them down when changing them if you don't have those huge lumps of steel they clip into?
.gif)
