Electronics Forum | Tue Feb 15 06:53:50 EST 2005 | cyber_wolf
It seems that every time we do maintenance on our CP6 windmills, we have a lot of problems with nozzles sticking up inside the holders. It seems to happen for a while, then it goes away after we run for a bit. We follow the Fuji maintenance procedure
Electronics Forum | Wed Jun 21 04:11:31 EDT 2006 | daxman
Are you familar with using the mecca mode on Fuji machines? There is a procedure I can take you through that will check the servo amp and allow you to adjust it. Is your machine useable at all? can you get it to pass zero set? If you can, view your s
Electronics Forum | Thu Mar 30 12:38:14 EST 2006 | Tech
Also why I am at it. In the book CP-6 Series Maintenance Manul ( Fuji Part # MNT-C060-11.3E ) in Chapter 4 page 4-1-11 it says " The clutches should therfore be cleaned regularly, using the grease cleaner (ThreeBond 2706) provided with the machine."
Electronics Forum | Wed Sep 13 20:04:37 EDT 2006 | mika
Hi, We have a customer that want us to produce a single sided 0.4 x 100 x 50 mm size RoHS pcba approx 1000 of them. The board only contains three 2.54mm pitch Non P.I.P, SMT-connectors. We have never produced such a thin pcb:s before. We are thinkin
Electronics Forum | Fri Nov 09 07:28:48 EST 2007 | jola
We have tested the Feeder Master and I have to say, we are not impressed at all. The main thing that we thought would be great with it was to test the feeders in full speed, but you dont get any data out from the machine so you only end up waching th
Electronics Forum | Thu May 29 14:57:26 EDT 2008 | rodrigo
Hi all, Is it normal for some of the small nozzles to be rejected by the wide view camera? Every time I do a nozzle centering the narrow view camera shows green circles for nozzles 1,2,3,4. The larger ones (5 and 6) show the asterisk. The wide view c
| 1 |
.gif)
