Electronics Forum | Tue Jan 24 08:01:32 EST 2012 | wolverine
When using the rectangular plate given with the machine that is used with calibrating the movable camera, does the longer side of the plate get fed into the machine ( rails set to 80mm ) or the shorter side ( rails set to 74mm ) Thanks Dave
Electronics Forum | Sun Jan 29 12:55:38 EST 2012 | tech_fun
i don't thing that it is a rule. the only ideea is to mov the camera exactly above the hole in the middle.
Electronics Forum | Thu Apr 01 23:53:26 EDT 2010 | dekhead
Sounds like SPC data collection is turned on with post print alignment inspection. Needs to be changed to "NONE" http://www.dekhead.com
Electronics Forum | Wed Dec 20 22:54:28 EST 2006 | fastek
I think that in this day and age.....if you are not testing the feeder via some sort of indexing proceedure while the feeder is off of the machine.....you are simply not going to be certain the feeder is working properly. The Alternative SMT jig do
Electronics Forum | Thu May 26 09:21:37 EDT 2016 | bobpan
Everytime I have seen an offset like that it was dirt on the quad-align lens.....try cleaning it off with alcohol and a lint free cloth. If this does not fix it....you may have dirt inside the quad align itself. I am assuming you have checked to ma
Electronics Forum | Thu May 26 15:13:47 EDT 2016 | bobpan
If there is dust (on the glass) off from the center of the lens it will add it to the part when scanning it and place off. I have ran into this twice.....I fixed it once by breaking the lens on the quad align and blowing it out.....another time I hel
Electronics Forum | Thu May 26 15:16:28 EDT 2016 | bobpan
oh ya....i forgot....to verify this....turn off all the extents for the parts and just pick them and place them....if they are very close to where they should be then it is the quad align causing the problem....this is how you can verify it. Copy the
Electronics Forum | Wed May 25 22:32:28 EDT 2016 | stevedc
So, I haven't used my Quad 4C for a while and when I started everything back up to run a new board it appears that the Quad align is in need of calibration. When I pick up a component and do an LAE measurement on it it shows the part center location
Electronics Forum | Thu May 26 17:45:36 EDT 2016 | stevedc
Thanks for the thoughts. I will try a few things tonight so see if I can clean anything from the windows. As always, thanks for your thoughts and time :) BR, Steve
Electronics Forum | Fri May 27 09:27:56 EDT 2016 | bobpan
Glad I can help....if you have any other questions...go to my web page @ www.precision-repairs.com Bob
winsouce.jpg)
