Electronics Forum | Fri Dec 19 17:11:24 EST 2014 | guts1872
My QSP2 motors keep shutting off with an error message on the screen that says Z1 motion fail. Z safe motion motion failed due to previous error. When homing the heads I observe the servo amp indicator LEDs. They are all green while the gantries are
Electronics Forum | Mon Dec 22 04:55:41 EST 2014 | bobpan
Swap the amps but first manually check by hand to make sure the z-axis is free to move up and down. Sometimes a part can get stuck in the gears. Good Luck
Electronics Forum | Fri Sep 18 03:02:07 EDT 2015 | linux
Hello everyone. Need urgent help with our cp6, when front door is open servo amp alarm comes up, this error will clear using the reset button. Has anyone any idea how I would go about fixing this issue.
Electronics Forum | Tue Apr 16 01:42:15 EDT 2019 | ledze91
Hello. Got problems with big elements like connectors. Pickup tolerance dont work on cp40/Lv. Here got two machines cp40/lv and one cp40/cv. On cv dont have problems with pickup, but on Lv nozzle hit the pins of connectors or wont pick up
Electronics Forum | Mon Jan 16 09:50:38 EST 2023 | mra
Hi Fern, I'm getting the same error on my CP40 and cannot clear it as well, did you finally find out what to do to solve it? Thanks in advance!
Electronics Forum | Thu Sep 09 13:41:43 EDT 2021 | fernsure
Tried suggested solution in manual to no avail. Reseated every connector we could get to. Has anyone run into this error, and found a solution? This error does not allow me to ignore this head and use the other two. Thanks Fern
Electronics Forum | Mon Jan 31 13:02:43 EST 2005 | jgarver1
Do you have an extra VME Servo Board to try? Servo Overflows are not as common as Over Currents or hard amplifier failures. They seem to be resolved by replacing the servo board and not the amp or motor. My $.02
Electronics Forum | Thu Jan 20 06:38:27 EST 2005 | unknown
Please contact NMTronics, they can give you some decent advice
Electronics Forum | Sun Jan 30 10:50:21 EST 2005 | jimmyb
Is it still happening, or did you already solve it?
.gif)
