Electronics Forum | vsuresh |
Sat Mar 23 05:36:36 EDT 2024
Electronics Forum | Thu Mar 28 19:36:21 EDT 2024 | linux
ensure the nozzle is inserting fulling into the nozzle holder. ensure shaft is lubricated, clean between the magnetics on the shaft. complete nozzle height calibration
Electronics Forum | Thu Nov 08 02:09:05 EST 2018 | vinitverma
If the nozzle gets changed properly but the machine still gives the sensor, then the FNC nozzle detection sensor needs to be adjusted. It is a set of 2 sensors on a plate on the either side of the FNC. If the nozzle is not changed successfully and ge
Electronics Forum | Thu Jun 04 09:40:38 EDT 2020 | kasia
Hi everyone, Im currently working on little bit old SMT machines (Europlacer) and I have problem with nozzles , everytime when I want to run a program I got information "26 nozzle not picked or error of detection". I restarted machine, checked the
Electronics Forum | Fri Jul 14 17:32:36 EDT 2023 | ttheis
Having an issue with changing nozzles on one of our FJ3 heads. We get errors on spindle 5 and 6 when bank-changing nozzles. Event code 31208, unable to find any info on this code. When we use the put nozzles away routine it does it no problem but has
Electronics Forum | Wed Oct 22 06:06:54 EDT 2008 | stanyserrao
1CA64011 and 1CAFE011 UsedBy Display 1CA??011 Cause The Vision_type in part data is expressed using hexadecimal notation ("??"). If "??" equals 1E, 64, 78, 79, AC, or FE then boundary detection could not begin because the nozzle was bent.
Electronics Forum | Wed Sep 04 13:58:36 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the response. 1. Function 30 gives me a consistent 182-185, even after nozzle changes. I can vary this by changing mod code 15 and I have been advised to aim for 90-110, but it doesn't seem to make any difference so I've go
Electronics Forum | Mon May 12 18:45:57 EDT 2008 | locostpp
Hi All, We are embarking on the design of an ultra low-cost pick and place machine for use by small manufacturers & would appreciate some input. Here are some points: Low cost - in the region of $6-11k (higher cost versions faster) Two cameras (up
| 1 |
