Electronics Forum | Mon Feb 26 11:10:59 EST 2024 | clpassoni
When the pick&place is at speeds above 80%, the X driver displays error 21, at lower speeds (
Electronics Forum | Tue Feb 27 00:31:36 EST 2024 | erikfriesen
What do you mean by driver? Maybe it's a weak encoder.
Electronics Forum | Tue Feb 27 10:34:37 EST 2024 | clpassoni
Servo motor. Maybe it's a weak encoder? This can happen? Is there any adjustment that can be made?
Electronics Forum | Wed Feb 28 01:10:33 EST 2024 | clpassoni
As I have two identical machines, it was easy, it really is the encoder, and as it is integrated into the motor it will be necessary to change the entire unit, or try to repair the encoder.
Electronics Forum | Tue Feb 27 11:43:18 EST 2024 | erikfriesen
I think error 21 at the drive is encoder communication issues, but google may tell you more. It's probably going to be one of three things, either the encoder, the cable, or the drive. I don't recall, but is the encoder integrated on the motor? If yo
Electronics Forum | Tue May 25 10:11:42 EDT 2021 | starsanat
Hello to you all. we got a CP45FV-NEO machine. it shows image1 error and I have no idea what this is for. please help me through it
Electronics Forum | Sat Jun 05 22:07:50 EDT 2021 | danniedarko
Hi, I live same error 3 years ago. I can fix this problem. but need remote access by (AnyDesk) software. and have 50USDT cost. send access information dannie.darko@outlook.com
Electronics Forum | Wed May 26 06:07:07 EDT 2021 | bukas
its not that you should never open it manually, it just can be a problem sometimes. CP45 have a few problems with data corruption and this can be one of them. just make sure you regularly backup disk, and dont delete old backups straight away.
Electronics Forum | Wed May 26 04:51:12 EDT 2021 | starsanat
Thank you for your attention. It shows an error on startup too, so it get closed by itself. when I start it manually it shows the above mentioned errors. So I should never open up Mark3 manually right? I'll clean everything up and tell you the result
Electronics Forum | Tue May 25 12:24:17 EDT 2021 | bukas
is Mark3 program started on startup or do you start it manually? It can be like this if you run it manually. Other cause is bad contact in PCB slot or connector in 90% cases. Wash then with contact cleaner and insert and pull out few times to clean c
