Electronics Forum | Tue Mar 07 09:35:55 EST 2017 | buckcho
hello, I have a problem with CP45FV Neo swing > mirror. The mirror it self works fine, manually > controlled it moves to correct position and back. > While working it also moves properly but when > machine is about to check for nozzle existence a
Electronics Forum | Wed Oct 12 02:44:38 EDT 2016 | bukas
hello, I have a problem with CP45FV Neo swing mirror. The mirror it self works fine, manually controlled it moves to correct position and back. While working it also moves properly but when machine is about to check for nozzle existence at the end of
Electronics Forum | Tue Mar 07 17:31:25 EST 2017 | kahrpr
The mirror should stay open. go to sys setup go to head go t nozzle check settings. that is were the nozzle check is at
Electronics Forum | Tue May 17 15:06:29 EDT 2016 | alexau
I would replace it on new one
Electronics Forum | Mon May 16 03:37:51 EDT 2016 | wesleyintelli
Update to the above. I swapped the swing mirror motor and cable across from our other Cp45 machine and the system homes correctly. It seems the second hand replacement motor may have been taken from the conveyor width adjustment assembly of another m
Electronics Forum | Mon May 16 00:33:18 EDT 2016 | wesleyintelli
Our CP45 swing mirror motor (Panasonic AC Servo Motor: MSMA012A3A) recently jammed and required replacement. I replaced the motor with a new one however it won't home. A link to a video of the motor attempting to home can be seen below. I am wonderin
Electronics Forum | Sat Mar 05 12:10:48 EST 2011 | dan_ems
Hello, we looking for a mirror for CP45 pick and place machine. Does anyone know were I can find this part? Thanks You!
Electronics Forum | Tue Sep 14 13:01:11 EDT 2021 | jamesatqkits
Hi Bukas, Every head, yes they move down, I should have mentioned the sensor is on the right , not the left. It detects the mirror swinging down. There is another sensor on the servo motor, its mirror home, it works I see it changing when I break the
Electronics Forum | Wed Aug 11 06:39:29 EDT 2021 | bukas
Hi James, make sure you have healthy HDD and disk image. These machines are a bit prone to data corruption after all these years and it can often look like hardware problem. I had a problem with mirror axis that turned out to be corrupted data. Ther
Electronics Forum | Thu Aug 12 15:39:36 EDT 2021 | bukas
it can be cable. can you swap cables with next driver? also swap cables on head. if same driver shows error you need new driver probably. if new driver shows error then its cables or motor. check documentation to see what motor it drives. you cant sw
