Electronics Forum | Tue Oct 11 19:17:29 EDT 2005 | Dave
Hi Stephen! The nozzle change happens at a much slower speed to what it runs at during pick and place. They are a great machine...when everything works on them ;-) I tried sending through the proper data again and rebooted the machine. A interest
Electronics Forum | Tue Sep 14 13:01:11 EDT 2021 | jamesatqkits
Hi Bukas, Every head, yes they move down, I should have mentioned the sensor is on the right , not the left. It detects the mirror swinging down. There is another sensor on the servo motor, its mirror home, it works I see it changing when I break the
Electronics Forum | Mon Sep 13 20:30:43 EDT 2021 | jamesatqkits
Hello all, thank you to the people that have been helping me out, Hristo and Bukas. I just thought I should put this out there and see if any one can help. When I try to pick up a nozzle I get the following error: [0800] <EMER&gt
Electronics Forum | Fri Mar 13 15:09:20 EDT 2015 | marcelorotofrance
Hello everybody Lately our machine has been working pretty well, but it can’t last too long. Now, during this week’s production cycle, it began to increase the component’s reject rate to alarming levels (obviously the operators reported me when the m
Electronics Forum | Thu Aug 04 09:40:12 EDT 2022 | jojoled
Hi, did anybody face such error(attached)? After calibrate all axis I get this error. "E202074 : Z axis of left head : SERVO alarm. Turn off the power to the machine and perform inspection" - see attachement. Machine was fully working day
Electronics Forum | Wed Nov 03 12:57:28 EDT 2010 | adrianam
I need some help with the following alarm appeared on Fuji FCP4-3 : ,,Servo Amplifier alarm on X, Y, C, Z axis". When I push the reset button, remain ,,Servo Amplifier Alarm on D, F theta axis". All the sensors and solenoid it were checked and is OK
Electronics Forum | Sat Aug 19 22:54:12 EDT 2023 | sonavc
Hi The machine run fine. Now I had the problem ZL or ZR driver Alarm. Turn on machine, everything is checked O.K I can be able to home the machine. When just start auto, the assembly or semi -auto. The machine is stopped, and show driver alarm ZL or
Electronics Forum | Thu Mar 21 12:09:28 EDT 2019 | alexcouto
Hello Bukas, thanks again. Since at an early stage I switched heads # 1 and # 6 and they are not compatible, then I went through the manual and figured out why. in order to start at the beginning and check that it had not damaged anything, I put the
| 1 |
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
winsouce.jpg)
