Electronics Forum | Tue Sep 01 12:20:47 EDT 2009 | fujiphil
Manually load the board and activate the solenoid for table up/down. Goto I/O then check the status of the sensor. if the sensor was tripped when table is down, removed the pin and check for foreign objects. Or check the hole of the pcb, maybe the si
Electronics Forum | Tue Sep 01 17:16:46 EDT 2009 | andoe
had tried all of that / went into proper data and changed the origin to the corner instead of the pin, it started working. thanks for the responce - ron
Electronics Forum | Mon Mar 23 15:38:31 EST 1998 | bill yates
I will convert your cp6 paper[red]8x4 feeders to plastic[yellow] feeders.email for more details
Electronics Forum | Wed Aug 26 17:06:56 EDT 2009 | andoe
when i transmitt data to the cp6 every thing seems to go okay until the end and i get a -- "A21E transmission error". i have checked the cable (i can program my IP3) any ideas? thanks ron
Electronics Forum | Tue Sep 01 11:46:09 EDT 2009 | andoe
when the cp6 loads a board everything seems normal / as the table drops the pcb lines up onto the origan hole and then instantly fails with -- "original pin error" we have run this board before. any ideas? thanks
Electronics Forum | Wed Jun 10 10:38:51 EDT 2015 | cyber_wolf
The published Fuji CP6 placing accuracy specification is plus/minus .1mm I would say that your machine is running just fine.
Electronics Forum | Thu Jun 11 03:59:00 EDT 2015 | linux
Sr Tech. Thanks for reply, We don't have the same issue with other cp6, was wondering was there anything else we could check?. Thanks again.
Electronics Forum | Wed Jun 29 09:05:38 EDT 2005 | jdengler
Try http://www.smtresearch.com/ But the price is not much cheaper than new ones.
Electronics Forum | Wed Jun 29 19:25:02 EDT 2005 | matjen
I found a place that exchanges old nozzles for new ones; thanks for the inputs though.
.gif)
